Skip to Content
EnergiesEnergies
  • Article
  • Open Access

19 November 2026

19 Pages

Photovoltaic Condition Assessment from I–V Curve Shape Alone: A Generic Normalized Reference Approach

,
,
,
,
,
and
Multidisciplinary Academic Unit, Altiplano Region, Autonomous University of San Luis Potosí, Cedral Highway km 5+600, Matehuala 78700, S.L.P., Mexico
*
Author to whom correspondence should be addressed.

Abstract

Photovoltaic (PV) diagnostic systems based on current–voltage (I–V) curve tracing commonly rely on irradiance and temperature measurements and module-specific datasheet parameters. This paper presents a model-based condition-assessment approach that uses a fixed generic normalized reference and only voltage and current measurements. Each measured I–V curve is normalized to its own open-circuit voltage and short-circuit current and compared with the reference using a pointwise absolute current residual. From this residual, two quantitative indicators are defined: the percentage residual area Pr and the maximum residual rmax. The approach is experimentally evaluated using 38 I–V sweeps, 19 under uniform irradiance and 19 under partial shading, showing that curve-shape deformations produce larger indicator values. A sensitivity analysis further shows that the separation between the two experimental conditions persists across the evaluated reference-parameter range, although the indicator magnitudes vary. The proposed method therefore provides a compact quantitative assessment of normalized I–V curve-shape deviations without requiring environmental measurements or module-specific electrical parameters during the assessment stage.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.