Energies, Volume 15, Issue 1

Heavy petroleum industries, including the Fluid Catalytic Cracking (FCC) unit, are among some of the biggest contributors to global greenhouse gas (GHG) emissions. The FCC unit’s regenerator is where these emissions originate mostly, meaning th...

Currently, the design of floating offshore wind systems is primarily based on mid-fidelity models with empirical drag forces. The tuning of the model coefficients requires data from either experiments or high-fidelity simulations. As part of the OC6...

Electric, hybrid, and fuel cell vehicles are the future of the automobile industry, and power source design is one of the most crucial steps in designing these vehicles. This paper aims to design and structurally simulate a custom accumulator—w...

Energy consumption for heating of single-family residential buildings is a basic item in energy balance and significantly affects their operating costs. Accuracy of heat consumption assessment in existing buildings to a large extent determines the de...

The smart transformer has been widely applied for the integration of renewables and loads. For the smart transformer application, the voltage control of low-voltage inverter is important for feeding the load. In this paper, a multi-objective optimiza...

In this article, the problem of modeling a time series using the Minimax method is considered. The expediency of using Minimax to identify points of change in trends and the range of changes in the graphical figures of technical analysis is justified...

Automated hydronic balancing in space heating systems is crucial for the fourth-generation district heating transition. The current manual balancing requires labor- and time-consuming activities. This article presents the field results of an innovati...

Due to a high risk of power outages, a heat-driven adsorption chillers are gaining the attention. To increase the efficiency of the chiller, new adsorbents must be produced and examined. In this study, four newly developed silica–based porous m...

The effectiveness of using wetted cellulose pads on improving the performance of two conventional passive cooling systems has been evaluated. First, an experimental design was developed to determine the impact of using a wetted cellulose pad on the t...

Preheating is often required to prevent hydrate formation during the pressure reduction process in a natural gas distribution network’s pressure reduction station. This paper examines an energy recovery method to avoid the cost and energy consu...