Skip to Content
You are currently on the new version of our website. Access the old version .
EnergiesEnergies
  • Article
  • Open Access

1 July 2022

38 Pages

DYN3D and CTF Coupling within a Multiscale and Multiphysics Software Development (Part II)

,
,
,
,
and
1
School of Engineering, University of Liverpool, Liverpool L69 3GH, UK
2
EDF Energy, Gloucester GL4 3RS, UK
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue Nuclear Engineering and Technology

Abstract

Traditionally, the complex coupled physical phenomena in nuclear reactors has resulted in them being treated separately or, at most, simplistically coupled in between within nuclear codes. Currently, coupling software environments are allowing different types of coupling, modularizing the nuclear codes or multi-physics. Several multiscale and multi-physics software developments for LWR are incorporating these to deliver improved or full coupled reactor physics at the fuel pin level. An alternative multiscale and multi-physics nuclear software development between NURESIM and CASL is being created for the UK. The coupling between DYN3D nodal code and CTF subchannel code can be used to deliver improved coupled reactor physics at the fuel pin level. In the current journal article, the second part of the DYN3D and CTF coupling was carried out to analyse a parallel two-way coupling between these codes and, hence, the outer iterations necessary for convergence to deliver verified improved coupled reactor physics at the fuel pin level. This final verification shows that the DYN3D and CTF coupling delivers improved effective multiplication factors, fission, and feedback distributions due to the presence of crossflow and turbulent mixing.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.