Skip to Content
SensorsSensors
  • Communication
  • Open Access

24 May 2022

16 Pages

Precision Measurement Method of Large Shaft Diameter Based on Dual Camera System

,
and
1
Institute of Engineering Technology, University of Science and Technology Beijing, Beijing 100083, China
2
Department of Mechanical Engineering, Baotou Vocational and Technical College, Baotou 014030, China
3
Collaborative Innovation Center of Steel Technology, University of Science and Technology Beijing, Beijing 100083, China
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue Optical Imaging, Optical Sensing and Devices

Abstract

At present, there is a problem that the measurement accuracy and measurement range cannot be balanced in the measurement of shaft diameter by the machine vision method. In this paper, we propose a large-scale shaft diameter precision measurement method based on a dual camera measurement system. The unified world coordinate system of the two cameras is established by analyzing the dual camera imaging model and obtaining the measurement formula. In order to verify the validity of the proposed method, two black blocks in the calibration plate with a known center distance of 100 mm were measured. The mean value was 100.001 mm and the standard deviation was 0.00039 in 10 measurements. Finally, the proposed system was applied to the diameter measurement of a complexed crankshaft. The mean μ95 values of CMM and the proposed method were ±1.02 μm and ±1.07 μm, respectively, indicating that the measurement accuracy of the proposed method is roughly equal to the CMM.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.