Skip to Content
You are currently on the new version of our website. Access the old version .
SensorsSensors
  • Article
  • Open Access

29 September 2017

11 Pages

A Light-Up Probe for Detection of Adenosine in Urine Samples by a Combination of an AIE Molecule and an Aptamer

,
,
,
,
and
1
Department of Food and Pharmaceutical Engineering, Key Laboratory of Fermentation Engineering (Ministry of Education), Hubei University of Technology, Wuhan 430068, China
2
Department of Chemistry, Wuhan University, Wuhan 430072, China
*
Author to whom correspondence should be addressed.
†
Yingying Hu and Jingjing Liu contributed equally to this work.
This article belongs to the Special Issue Fluorescent Probes and Sensors

Abstract

A light-up fluorescent probe for the detection of adenosine was constructed with an AIE (aggregation-induced emission) molecule and a DNA aptamer. The AIE molecule was used as a signal generator, and the DNA aptamer was used as a recognition element for adenosine. The emission of the AIE molecule was due to its intramolecular rotation restriction induced by the aptamer upon binding of adenosine. The optimal component ratio of the probe was AIE molecule / DNA aptamer = 100 (μM/μM). The calibration curve of adenosine detection showed a linear range of 10 pM to 0.5 μM with an R2 of 0.996, and the detection limit of the probe was 10 pM. The probe exhibited a good selectivity to adenosine against its analogs (uridine, guanosine, and cytidine). The probe was used to detect adenosine in urine samples, a recovery from 86.8% to 90.0% for the spiked concentrations of adenosine (0.01, 0.05, 0.1 μM). The relative standard deviation from 1.2% to 2.0% was obtained. The intra-day and inter-day tests also showed good precisions, with measurement RSD values of 2.3% and 2.1%, respectively.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.