Accuracy Improvements in Machine Tools and Machining
A special issue of Journal of Manufacturing and Materials Processing (ISSN 2504-4494).
Deadline for manuscript submissions: closed (31 July 2021) | Viewed by 2962
Special Issue Editors
Interests: coordinate metrology (in scales ranging from nanometers to large volume objects); in-process metrology; coordinate measuring systems (including portable measuring systems and computed tomography systems); measurement accuracy; simulation and numerical methods in metrology (especially the Monte Carlo method); methods for identifying and correcting geometric errors of machines
Special Issues, Collections and Topics in MDPI journals
Interests: coordinate measuring technique; contact and contactless measurements; simulation and modeling of measuring systems, especially those with open kinematic chain; coordinate metrology in medicine and bioengineering; in-process/in-line metrology
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
In recent years, the demand for accurate machining and precise assembly of components in a way that makes it possible to locate and align them together in a much closer proximity has grown significantly. The demands put forward by recent innovations in the fields of nano-, micro-, and ultra-precision machining create a need for the development of novel methods for identification and correction of errors influencing machining, selection of optimal manufacturing parameters, and calibration and verification of machine tools. All of that is in order to push forward the machining capabilities, which in turn may bring very positive long-term effects, including reduction of friction in powertrain solutions leading to a decrease in emission of pollution, reduction of energy consumption, reduction of the amount of machining allowances, and reduction of time, costs, and energy expenditure for the purposes of mechanical processing.
In this Special Issue of JMMP, we are looking for recent findings, which focus on accuracy improvements in machine tools and machining. We invite contributions on topics including but not limited to the following areas:
- Identification and compensation of machine tool errors;
- Selection of optimal machining parameters;
- Metrology systems integrated in manufacturing tools and lines;
- Optical metrology in manufacturing (vision-based measurement systems, fringe optics, laser triangulation, etc.);
- Machine tool performance;
- Calibration and verification of machine tools;
- Artefacts for machine verification;
- Uncertainty estimation;
- System accuracy modeling.
Prof. Dr. Adam Gąska
Prof. Dr. Ksenia Ostrowska
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Journal of Manufacturing and Materials Processing is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 1800 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- machine tool
- correction systems
- inspection
- verification
- calibration
- error identification
- uncertainty estimation
