- 2.3Impact Factor
- 4.9CiteScore
- 17 daysTime to First Decision
Wind Tunnel Simulation and Atmospheric Diffusion Study
This special issue belongs to the section “Atmospheric Techniques, Instruments, and Modeling“.
Special Issue Information
Dear Colleagues,
Most would agree that the wind tunnel modelling of atmospheric flow and dispersion began in the late 1950s in Jack Cermak’s laboratory at Colorado State University. Indeed, Cermak is often referred to as the ‘father of wind engineering’, and deservedly so. Although dispersion modelling was subsequently developed at a number of key centres around the world, it was considered the minor part of wind engineering, which concentrated on wind loading and related matters. This was not entirely justified but was particularly obvious at the major wind engineering conferences, leading to the formation of a separate set of meetings, commencing with the 1982 workshop on wind tunnel dispersion tests at MT-TNO in the Netherlands. This eventually led to the Physmod (physical modelling of atmospheric flow and dispersion) international conferences from 1999 onwards. The subject shares much in common with mainstream wind engineering but has its own distinct character and challenges, which was why a separate and focused conference series was important.
A Special Issue of Atmosphere is to be devoted to the subject, tracing its history and achievements, as well as highlighting current research and debating future directions and prospects. This should cover basic and applied research and applications. The intention is that the Issue will provide a ‘showcase’ for the subject and its practitioners.
Prof. Dr. Alan Robins
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Atmosphere is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- wind tunnel
- water tank
- instrumentation
- boundary layer simulation
- dispersion
- plumes and puffs
- complex flows
- basic research
- applied research
- validation
- specific applications
Benefits of Publishing in a Special Issue
- Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
- Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
- Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
- External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
- e-Book format: Special Issues with more than 10 articles can be published as dedicated e-books, ensuring wide and rapid dissemination.

