Skip to Content
  • Proceeding Paper
  • Open Access

16 November 2026

Centrifugal RPM as an Active Phase-Selection Parameter in Liquid-Phase-Exfoliated Graphene †

,
and
1
School of Chemical & Materials Engineering, National University of Science & Technology, Islamabad 44000, Pakistan
2
Department of Materials Science & Engineering, Pak-Austria Fachhochschule, Institute of Applied Science & Technology, Haripur 22650, Pakistan
*
Author to whom correspondence should be addressed.
†
Presented at the 7th Conference on Emerging Materials and Processes (CEMP 2026), Islamabad, Pakistan, 9–10 February 2026.
Eng. Proc.2026, 166(1), 4;https://doi.org/10.3390/engproc2026166004 
(registering DOI)
This article belongs to the Proceedings of The 7th Conference on Emerging Materials and Processes

Abstract

Liquid-phase exfoliation is used as a scaled-up method for graphene synthesis; centrifugal separation is used as a thickness sorting process. RPM induces changes in interlayer coherence, defect density, morphology, and surface chemistry, as revealed by a systematic analysis of structure, morphology, and surface chemistry. This indicates selective attenuation of functionalization, leading to increased optical transparency. High RPMs increase the prevalence of basal-plane structures and yield enlarged graphene structures with lower edge disorder, whereas low RPMs maintain a stacked structure with a higher defect ratio. Therefore, RPM can be used as an adjustable kinetic parameter in the manufacture of graphene.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.