Highlights
What are the main findings?
- A cooperative CTDE-TD3 framework is developed for high-precision trajectory tracking of a 5-DOF robotic manipulator, using resistive-loss energy proxies and a theoretical constraint to reduce torque oscillations and improve control smoothness.
- The proposed framework reduces tracking RMSE by 54.5% and squared-torque control effort (a copper-loss proxy) by 33.1% compared with centralized TD3.
- Cooperative multi-agent control can lower actuator effort and improve control smoothness, supporting energy-efficient industrial automation.
- The approach shows how learning-based robot control can contribute to the relevant United Nations Sustainable Development Goals (SDGs).
Abstract
Control software that lowers actuator effort without degrading precision can be deployed on installed industrial robots without new hardware. This paper formulates trajectory tracking of a 5-degree-of-freedom (DOF) Mitsubishi RV-2AJ arm as a fully cooperative multi-agent problem, in which each joint is driven by a twin delayed deep deterministic policy gradient (TD3) agent under centralized training and decentralized execution (CTDE). Unlike MADDPG, MATD3 and MAPPO, the proposed CTDE-TD3 combines (i) a single twin centralized critic, shared by all joint agents and conditioned on all joint states and torques, which removes the non-stationarity faced by independent agents while each actor uses only three local measurements at run time; (ii) a shared reward with an inter-joint torque-covariance term, whose exact decomposition yields the admissible weight condition μ ≤ 2λ; and (iii) a dimensionless weight normalization. In simulation on three 3D reference trajectories over 10 training seeds, the controller reduced the tracking root-mean-square error (RMSE) by 54.5% and 37.5% and the squared-torque effort by 33.1% and 21.0% relative to centralized and independent-agent TD3, respectively. It was not dominated by MADDPG, MATD3, MAPPO or a tuned proportional–integral–derivative (PID) controller on unseen trajectories. Ablations and a capacity-matched centralized baseline show that the gains stem from the cooperative structure rather than from network size. Because the squared-torque index reflects control effort and copper loss rather than total electrical energy, electricity and CO2 savings are reported only as scenario estimates pending hardware validation.