Skip to Content
CC
  • Article
  • Open Access

14 February 2023

26 Pages

Valorization of Exhausted Olive Pomace for the Production of a Fuel for Direct Carbon Fuel Cell

,
,
and
1
Laboratory of Systems Integration and Emerging Energies (LR21ES14), National Engineering School of Sfax (ENIS), University of Sfax, IPEIS Road Menzel Chaker km 0.5, P.O. Box 1172, Sfax 3018, Tunisia
2
Digital Research Center of Sfax, Technopole of Sfax, Sakiet Ezzit, P.O. Box 275, Sfax 3021, Tunisia
3
State Key Laboratory of Chemical Engineering, Tianjin University, Tianjin 300072, China
4
Tianjin Key Laboratory of Applied Catalysis Science and Technology, School of Chemical Engineering, Tianjin University, Tianjin 300072, China
This article belongs to the Special Issue Biomass—a Renewable Resource for Carbon Materials

Abstract

In this study, exhausted olive pomace (EOP) biochar prepared by carbonization at 400 °C is investigated as a fuel in a direct carbon fuel cell (DCFC) with an electrolyte-supported configuration. The feasibility of using the EOP biochar in the DCFC is confirmed, showing a maximum power density of 10 mW·cm−2 at 700 °C. This limited DCFC performance is compared with other biochars prepared under similar conditions and interrelated with various biochar physico-chemical characteristics, as well as their impact on the DCFC’s chemical and electrochemical reaction mechanisms. A high ash content (21.55%) and a low volatile matter (40.62%) content of the EOP biochar are among the main causes of the DCFC’s limited output. Silica is the major impurity in the EOP biochar ash, which explains the limited cell performance as it causes low reactivity and limited electrical conductivity because of its non-crystal structure. The relatively poor DCFC performance when fueled by the EOP biochar can be overcome by further pre- and post-treatment of this renewable fuel.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.