Skip to Content
CoatingsCoatings
  • Article
  • Open Access

21 November 2026

21 Pages

Residual Stress Analysis of Thermal Barrier Coatings Exposed to High Temperature Using Hard Synchrotron X-Rays and the Direct Method

,
and
1
Faculty of Education, Niigata University, Ikarashi-2-no-cho, Nishi-ku, Niigata 950-2181, Japan
2
Materials Science Research Center, Nuclear Science Research Institute Organization: Japan Atomic Energy Agency, 2-4 Shirakata, Tokai-mura, Naka-gun, Ibaraki 319-1195, Japan
3
Materials Science Research Center, Nuclear Science Research Institute Organization: Japan Atomic Energy Agency, 1-1-1 Kouto, Sayocho, Sayo-gun, Hyogo 679-5148, Japan
*
Author to whom correspondence should be addressed.
Coatings2026, 16(12), 1385;https://doi.org/10.3390/coatings16121385 
(registering DOI)
This article belongs to the Special Issue Thermal Insulation, Durability, and Cost-Effective Multi-Objective Optimization of Turbine Blades with Thermal Barrier Coatings

Abstract

A bond coat of NiCoCrAlY and a top coat of zirconia with 8% yttria were applied to a nickel-based superalloy substrate using atmospheric plasma spraying. High-temperature oxidation specimens were prepared by exposing the coated samples to air at 1373 K for durations of 0, 500, and 1000 h. Specimens with a width of 3.5 mm were cut from these samples to measure the residual stress distribution throughout the coating layers. The experiments were conducted at the SPring-8 synchrotron radiation facility. An incident beam with an energy of 69.4 keV and a height of 10 μm was transmitted through the specimens, and diffraction patterns were measured using an area detector. For the oxidized specimens, this study marked the first successful measurement of diffraction from alumina which is a thermally grown oxide (TGO), in addition to the top and bond coats. Stress was analyzed using the direct method based on the diffraction data obtained from each layer, and the distributions for both in-plane and out-of-plane residual stresses were obtained. The results revealed that residual stresses arising from the difference in thermal expansion between the top and bond coats were generated near their interface. The TGO, which is formed between the top and bond coats, possessed residual stresses which were far greater than those of the top coat.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.