Skip to Content
You are currently on the new version of our website. Access the old version .
CoatingsCoatings
  • Article
  • Open Access

27 June 2023

13 Pages

Effect of Ultrasonic Impact on the Organization and Friction Wear Performance of AZ31B Magnesium Alloy Micro-Arc Oxidation Composite Coating

,
,
,
,
,
and
1
College of Engineering, Heilongjiang Bayi Agricultural University, Daqing 163319, China
2
Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 200050, China
*
Author to whom correspondence should be addressed.

Abstract

To enhance the frictional wear performance of AZ31B magnesium alloy, a nanocrystalline layer was prepared by ultrasonic impact (UI) treatment on magnesium alloy samples, and the effects of different ultrasonic impact times (5 min, 10 min, and 15 min) on the organization and wear resistance of the composite coating were studied. The findings revealed that the maximum thickness of the composite coating was about 50 μm after 10 min of impact time, which was approximately 15 μm higher than that of the MAO coating. The elemental composition of the composite coating was mainly Mg, O, and Si elements, and the phase structure of the coating, mainly MgO and Mg2SiO4, was the same before and after UI. The microhardness value gradually decreased in a gradient with the increasing distance from the sample surface. The coating had a lower average coefficient of friction (0.18) and lower wear loss (1.56 mg) for the 15 min impact time. Moreover, a small amount of abrasive and adhesive wear served as the primary modes of wear.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.