Skip to Content
Applied SciencesApplied Sciences
  • Article
  • Open Access

12 May 2023

19 Pages

Ball Milling and Consolidation Process of Al-Cr Powder Mixture—Microstructural Characterization

,
,
,
,
and
1
Department of Materials Engineering, Technological of Superiors Studies of Coacalco, Av. 16 de Septiembre 54, Cabecera Municipal, Coacalco 55700, Estado de México, Mexico
2
Department of Chemical Engineering and Metallurgy, University of Sonora, Blvd. Luis Encinas y Rosales S/N, Col. Centro Hermosillo, Hermosillo 83000, Sonora, Mexico
3
Department of Engineering in Design, Polytechnic University of the Guadalajara Metropolitan Zone, Av. Adolfo B. Horn 8941, Cajititlán 45670, Jalisco, Mexico
4
Department of Chemical Engineering, Technological University of Mexico (UNITEC), Calzada Lázaro Cárdenas 405, Lomas de Tlaquepaque, San Pedro Tlaquepaque 45559, Jalisco, Mexico
This article belongs to the Section Materials Science and Engineering

Abstract

The interest in studying the synthesis of an Al–Cr alloy system by non-equilibria processes is due to the formation of metastable or quasicrystalline phases when rapid solidification has been utilized. Similarly, the formation of quasicrystals has been reported to a much lesser extent when the mechanical alloying technique was applied. In the present research, a mixture of powders of Cr and Al (both elements with a purity of 99.99%) with compositions of Al-5 and 7.5 at. % Cr was subjected to a ball milling process. Afterwards, the powder mixture was subjected to a consolidation process, conducted by pressing and sintering processes. The X-ray diffraction analyses revealed that during 20 h of milling there was no formation of metastable or quasicrystalline second phases detected. In addition, the X-ray diffraction peaks revealed that as milling time increased, the nanometric grain size decreased, and once the sintering treatment was applied, the crystallite size decreased following the same tendency. The dislocation density was estimated using the size of nanometric grains; this computation revealed that the dislocation density grew throughout the ball milling process; even after sintering, the multiplication of dislocations prevailed following the same tendency.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.