Skip to Content
BuildingsBuildings
  • Article
  • Open Access

20 November 2026

25 Pages

Study on the Physical, Mechanical, Microscopic and Durability Properties of Artificial Aggregate from Waste Travertine Powder

,
,
,
,
,
,
,
and
1
College of Mechanical and Electronic Engineering, Nanjing Forestry University, Nanjing 210037, China
2
Department of Civil and Environmental Engineering, The University of Liverpool, Liverpool L69 3BX, UK
3
Department of Construction Management, Nanjing Forestry University, Nanjing 210037, China
4
School of Mechanics and Construction Engineering, Jinan University, Guangzhou 510632, China
Buildings2026, 16(22), 4639;https://doi.org/10.3390/buildings16224639 
(registering DOI)
This article belongs to the Special Issue Advances in Cementitious Materials and Concrete Structures

Abstract

To promote the resource utilization of travertine waste and alleviate the shortage of natural aggregates, artificial aggregates were prepared by cold-bonding granulation using 70% waste travertine powder as the main raw material and 30% binders (cement, fly ash, and GGBS). Four binder systems were designed: a pure cement system, a cement–fly ash binary system, and two cement–fly ash–GGBS ternary systems. The effects of the binder system on the physical properties, mechanical properties, microstructure, and freeze-thaw durability were investigated. Results showed that the binder system clearly influenced aggregate performance. In the pure cement system (G1), sufficient hydration products produced a denser internal structure and better freeze-thaw resistance. The cylindrical and particle compressive strengths reached 6.23 MPa and 3.04 MPa respectively, and the mass loss rate after 25 freeze–thaw cycles was only 2.27%. With fly ash, the delayed early pozzolanic reaction resulted in a more porous structure and inferior overall performance. The strength loss of G2 was nearly half that of G1, while higher porosity and water absorption rates were observed. The addition of GGBS promoted additional gel formation through latent hydraulic reactions, enhancing pore filling and structural densification and thus improving overall performance. G4, with higher GGBS content, performed better: its cylindrical and particle compressive strengths were 34% and 39% higher than those of G2, respectively; its water absorption and porosity were 16% and 21% lower than those of G2, respectively. These results confirm that high-content travertine powder artificial aggregates can be feasibly produced using a cement–fly ash–GGBS multi-component cementitious system, offering a sustainable route for travertine waste utilization and environmental benefits.

Article Metrics

Citations

Article Access Statistics

Article metric data becomes available approximately 24 hours after publication online.