Skip to Content
MetalsMetals
  • Article
  • Open Access

15 November 2026

40 Pages

Influence of Laser-Induced Surface Texturing on the Corrosion Resistance of PEO-Coated Biodegradable Magnesium Alloys

,
,
,
,
,
,
and
1
Research Centre, University of Žilina, Univerzitná 8215/1, 010 26 Žilina, Slovakia
2
Faculty of Electrical Engineering and Information Technology, Department of Physics, University of Žilina, Univerzitná 8215/1, 010 26 Žilina, Slovakia
3
Department of Metals and Corrosion Engineering, University of Chemistry and Technology, Technická 5, 166 28 Prague, Czech Republic
4
Department of Physics of Materials, Charles University, Ke Karlovu 5, 121 16 Prague, Czech Republic

Abstract

This study investigates the effect of laser-induced surface texturing on the corrosion resistance of biodegradable ZX10 and WE43 magnesium alloys, both in the PEO-free state and after subsequent plasma electrolytic oxidation (PEO). Two laser scanning strategies, patterned and full-coverage treatment, were applied at 30, 65 and 100% of the maximum pulse energy. The laser-treated surfaces were characterised by confocal microscopy and scanning electron microscopy (SEM) while the morphology and thickness of the subsequently formed PEO coatings were evaluated by SEM. Corrosion resistance was assessed by electrochemical impedance spectroscopy (EIS) in 0.9% NaCl during the initial 24 h of immersion, while selected representative conditions were further evaluated during extended immersion up to 168 h. The patterned laser treatment produced discrete dimple-like surface features while full-coverage treatment generated more anisotropic laser-affected ridged morphology, especially at lower and intermediate pulse energies. PEO coatings with comparable thicknesses were formed on all laser-treated surfaces; however, their pore morphology strongly depended on the initial laser-induced surface relief. The corrosion response was strongly alloy-dependent. For ZX10, PEO coating formation improved the corrosion resistance compared with the PEO-free laser-treated surfaces, and the FC65 + PEO condition retained the highest resistance among the selected ZX10 states after 168 h. In contrast, for WE43, the best long-term response was obtained for the PEO-free P65 laser-treated surface, indicating that the beneficial effect of laser-assisted PEO treatment was strongly alloy-dependent.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.