Skip to Content
You are currently on the new version of our website. Access the old version .
MetalsMetals
  • Article
  • Open Access

28 July 2020

10 Pages

Effect of Mo Addition on The Microstructure and Mechanical Properties of CoCuFeNi High Entropy Alloy

,
and
1
Department of Materials Science and Engineering, Dalian Maritime University, Dalian 116026, China
2
Department of Materials Science and Engineering, City University of Hong Kong, Hong Kong 999077, China
*
Author to whom correspondence should be addressed.

Abstract

In order to reveal the effect of Mo addition on the microstructure and mechanical properties, (CoCuFeNi)100-xMox (x = 0, 10, 15, 19, and 25, x values in atomic ratio) high entropy alloys were prepared by vacuum arc-melting. The results showed that with Mo addition, the μ phase formed and serious separation occurred in the high entropy alloys. The content of μ phase increased with the increase in Mo content. The microstructure of the alloys changed from an initial single-phase face-center-cubic (FCC) solid solution structure (x = 0) to a hypoeutectic microstructure (x = 15), then to a full eutectic microstructure (x = 19), and finally to a hypereutectic microstructure (x = 25). Coherent interface between μ phase and FCC phase was observed. The (CoCuFeNi)81Mo19 alloy with fully eutectic microstructures exhibited the highest yield strength of 557 MPa and fracture strength of 767 MPa in tensile tests at room temperature. The fracture surface revealed that the formation of great amounts of the μ phase resulted in the loss of ductility of (CoCuFeNi)100-xMox alloys.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.