Skip to Content
MachinesMachines
  • Article
  • Open Access

17 November 2026

32 Pages

Dynamic Modeling and Experimental Validation of Dual-Link Flexible Manipulators Using the Global Mode Method

,
,
,
,
and
1
Key Laboratory of Metallurgical Equipment and Control Technology, Ministry of Education, Wuhan University of Science and Technology, Wuhan 430081, China
2
Hubei Key Laboratory of Mechanical Transmission and Manufacturing Engineering, Wuhan University of Science and Technology, Wuhan 430081, China
3
Science and Technology, School of Mechanical Engineering, Wuhan University of Science and Technology, Wuhan 430081, China
4
School of Mechanical and Electrical Engineering, Wuchang Shouyi University, Wuhan 430064, China
This article belongs to the Section Automation and Control Systems

Abstract

Compared with their rigid counterparts, the dual-link flexible robotic manipulator (DLFRM) features lighter links, lower inertia, and higher deployment flexibility. However, joint coupling and link elasticity introduce complex nonlinear dynamic characteristics that complicate the modeling process. To conduct a comprehensive analysis of the dynamic characteristics of the DLFRM, this study proposes a low-dimensional dynamic modeling method based on the global modal method (GMM). A corresponding nonlinear response analysis framework is established. The proposed approach incorporates the linearized dynamic equations and boundary conditions into the global modal formulation and represents the elastic deformations of both links using a unified set of global modal coordinates, resulting in a low-dimensional dynamic model of the DLFRM. The modal characteristics predicted are validated by comparing the natural frequencies (NFs) and mode shapes with those obtained from finite element method (FEM) analysis. The convergence analysis of the system response indicates that the first two global modes are sufficient to achieve accurate predictions of the system response. Moreover, the GMM provides a more stable elastic response, while achieving a computational efficiency of approximately 15.6% in both total and per-step computational cost, compared to that of the assumed mode method (AMM). The proposed model is further validated in terms of its modal characteristics and system response through impact-hammer tests and dynamic-response measurements. This study presents a new approach to DLFRM dynamic modeling and lays the foundation for system dynamic modeling, response analysis, and vibration suppression. Furthermore, the proposed approach can be extended to multi-link flexible manipulator systems.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.