Skip to Content
You are currently on the new version of our website. Access the old version .
PolymersPolymers
  • Article
  • Open Access

19 August 2019

11 Pages

Effect of Formation Route on the Mechanical Properties of the Polyethersulfone Composites Reinforced with Glass Fibers

,
,
and
Center of composite materials, National University of Science and Technology “MISIS”, Leninskii prosp, 119049 Moscow, Russia
*
Author to whom correspondence should be addressed.
This article belongs to the Collection Reinforced Polymer Composites

Abstract

Interfacial interaction is one of the most important factors that affect the mechanical properties of the fiber reinforced composites. The effect of fabrics′ sizing removal from glass fibers’ surface by thermal treatment on the mechanical characteristics of polyethersulfone based composites at different fiber to polymer weight ratios was investigated. Three fiber to polymer weight ratios of 50/50, 60/40, and 70/30 were studied. Flexural and shear tests were carried out to illustrate the mechanical properties of the composites; the structure was studied using Fourier-transform infrared spectroscopy and scanning electron microscopy. It was shown that solution impregnation of glass fabrics with polyethersulfone before compression molding allows to achieve good mechanical properties of composites. The thermal treatment of glass fabrics before impregnation results in an increase in flexural and shear strength for all the composites due to the improvement of fiber–matrix interaction.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.