Skip to Content
You are currently on the new version of our website. Access the old version .
CatalystsCatalysts
  • Article
  • Open Access

28 February 2023

15 Pages

Application of Biochar from Woodchip as Catalyst Support for Biodiesel Production

,
,
,
and
1
Department of Science and Technology, Faculty of Humanities, Management and Science, Universiti Putra Malaysia Bintulu Sarawak Campus, Bintulu 97008, Malaysia
2
Institut Ekosains Borneo, Universiti Putra Malaysia Bintulu Sarawak Campus, Bintulu 97008, Malaysia
3
Department of Bioprocess Technology, Faculty of Biotechnology and Biomolecular Sciences, Serdang 43400, Malaysia
*
Author to whom correspondence should be addressed.
This article belongs to the Section Biomass Catalysis

Abstract

In Asian countries, the primary palm oil producers, used cooking oil (UCO) is the primary feedstock for biodiesel production. It can be converted into an eco-fuel for application in heavy machinery and diesel engine vehicles due to its low carbon emissions and low global warming potential. However, the illegal dumping of UCO containing triglyceride into flowing water bodies (resulting in wastewater treatment and purification complications) has prompted the design of smart UCO collection systems. This study aims to investigate the heterogeneous catalytic performance of biochar as a support catalyst derived from woodchips calcined at 400 °C and 800 °C under nitrogen gas flow. The catalyst was synthesized through the wet impregnation method using two metal oxides (5 wt.%, nickel and molybdenum) via transesterification to enhance the biodiesel yield. High biodiesel yield was obtained through the controlled parameters: 65–95 °C temperature, 10:1 methanol to oil ratio, and 2 h reaction time. The synthesized catalyst was characterized through X-ray Diffraction (XRD) and Field Emission Scanning Electron (FESEM). The biodiesel production was confirmed by Fourier Transform Infra-Red (FTIR) Spectroscopy. The results showed that the highest biodiesel yield was produced by the catalyst calcined at 800 °C, which shows a consistent trend in the yields obtained at temperatures in the order 75–85–95–65 °C. In conclusion, calcination at 800 °C resulted in a higher yield (74.66%) and catalyst reusability (≥5 cycles).

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.