Heavy Metal Retention by Different Forest Species Used for Restoration of Post-Mining Landscapes, N. Greece
Forest Research Institute of Thessaloniki, ELGO-DEMETER, 57006 Thessaloniki, Greece
*
Author to whom correspondence should be addressed.
Sustainability 2020, 12(11), 4453; https://doi.org/10.3390/su12114453
Received: 11 May 2020 / Revised: 25 May 2020 / Accepted: 27 May 2020 / Published: 30 May 2020
(This article belongs to the Special Issue Current Advances on Ecological Modeling for Sustainable Forest Management)
The main objective of this research was to study heavy metal absorption by the leaves of main forest species which were planted for that purpose at post-lignite mining landscapes in Northern Greece (Ptolemais, Prefecture of Kozani), as well as in a neighboring region (Kato Grammatiko), 30 km far from the mining area. Four species were studied; two conifers (Pinus nigra Arn., Cupressus arizonica Greene) and two broad-leaved (Robinia pseudoacacia L., Populus nigra L.). The four species varied in their leaf morphology (needles, scale-like leaves, blade, compound or simple, with rough or smooth surfaces). Eighty (80) leaf samples were collected, (10 from each tree species at either site). The heavy metal concentrations measured were iron (Fe), copper (Cu), chromium (Cr), nickel (Ni), cadmium (Cd), manganese (Mn), zinc (Zn) and cobalt (Co). Statistically significant differences (p = 0.01) were found between the lignite deposit and control areas and among the studied species. Higher concentrations were measured for the studied species at the lignite deposit. Moreover, no species demonstrated maximum absorption for all metals. The metal absorption pattern by coniferous trees’ leaves at the mining landscape was similar, with highest concentrations observed for iron and lowest for cobalt [iron (Fe) > zinc (Zn) > manganese (Mn) > copper (Cu) > chromium (Cr) > nickel (Ni) > cobalt (Co)]. Both broadleaved species absorbed highest concentrations of iron, but differed in the amount of the remaining metals [black locust: iron (Fe) > manganese (Mn) > zinc (Zn) > copper (Cu) > nickel (Ni) > chromium (Cr); black poplar: iron (Fe) > zinc (Zn) > manganese (Mn) > copper (Cu) > nickel (Ni) > chromium (Cr) > cobalt (Co)]. Cadmium was detected only in black poplar at both sites. In general, black pine was found to absorb the highest concentration of iron (Fe), and black poplar zinc (Zn). We discuss the importance of carefully selecting the appropriate mixture of tree species in order to achieve maximum habitat restoration effect at heavy metal polluted sites.
View Full-Text
This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited
MDPI and ACS Style
Samara, T.; Spanos, I.; Platis, P.; Papachristou, T.G. Heavy Metal Retention by Different Forest Species Used for Restoration of Post-Mining Landscapes, N. Greece. Sustainability 2020, 12, 4453. https://doi.org/10.3390/su12114453
AMA Style
Samara T, Spanos I, Platis P, Papachristou TG. Heavy Metal Retention by Different Forest Species Used for Restoration of Post-Mining Landscapes, N. Greece. Sustainability. 2020; 12(11):4453. https://doi.org/10.3390/su12114453
Chicago/Turabian StyleSamara, Theano, Ioannis Spanos, Panagiotis Platis, and Thomas G. Papachristou 2020. "Heavy Metal Retention by Different Forest Species Used for Restoration of Post-Mining Landscapes, N. Greece" Sustainability 12, no. 11: 4453. https://doi.org/10.3390/su12114453
Find Other Styles
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.
