Abstract
The properties of the corrosion product layer on the steel surface determine the corrosion behavior of the substrate metal. However, quantitative micro-scale characterization methods during the growth process of the corrosion product layer remain limited, impeding the establishment of structure-property relationships. In this paper, weight loss and in situ electrochemical measurements were carried out to study the influence of immersion duration on the corrosion behavior of N80 steel. It is shown that CR (corrosion rate) remarkably decreased with immersion duration, from 15.105 mm/a at 2 h to 0.325 mm/a at 144 h, with 2 MPa CO2 at 120 °C and a total immersion duration of 144 h. The corrosion product layers obtained at different immersion durations were analyzed with SEM, XRD and Synchrotron radiation computed laminography (SRCL). The maximum porosity of the corrosion product layer gradually decreased from 11.193% to 1.732%, with the immersion duration increasing from 2 h to 144 h. The growth mechanism and relationship between layer structure and corrosion rate were also proposed. At low CR values, an exponential relationship exists between CR and maximum porosity. At high CR values, a simple linear relationship can be obtained. At low CR values, both IPA/d (integral porosity area per unit thickness) and IPA (integral porosity area) show linear correlations with CR, whereas at high CR values, they follow a double exponential relationship.