Abstract
Thermal interface materials (TIMs) are critical for safe and efficient operation of electric vehicle battery packs, yet no review integrates their thermal behavior, mechanical behavior, simulation methodology, and manufacturing constraints within a unified multidisciplinary framework. This review addresses that gap. Interfacial contact resistance dominates total thermal impedance over bulk conductivity across the bond-line thickness (BLT). Liquid-dispensed gap fillers remove 47% more heat than pre-cured thermal pads and 62% more than no-TIM systems under comparable conditions. Advanced TIMs challenge conventional limits: oriented BN/PDMS films achieve through-plane thermal conductivities of 12.1–23.7 , while vertically aligned graphene-foam TIMs reach . Mechanically, surface roughness increases pull-off stress by approximately 17%, shifting failure from adhesive to cohesive, while bond-line thickness decreases from mm to mm as compressive force increases from N to 6 N. A 10 Hz vibration reduces maximum temperature in a phase-change material (PCM) covered battery by %, whereas silica-gel-based PCMs reduce system temperature by approximately 15% under 2C discharge and suppress thermal-runaway propagation. These findings highlight the need for unified pack-level multiphysics models and reliability testing under realistic EV battery-specific operating conditions for the next generation high-performance EV systems.