Skip to Content
You are currently on the new version of our website. Access the old version .
SensorsSensors
  • Article
  • Open Access

16 November 2026

20 Pages

Probe Wave Parameter Optimization for Vibro-Acoustic Modulation in Bolt Loosening Monitoring

,
and
Rocket Force University of Engineering, Xi’an 710025, China
*
Author to whom correspondence should be addressed.
Sensors2026, 26(22), 7227;https://doi.org/10.3390/s26227227 
(registering DOI)
This article belongs to the Special Issue Acoustic and Ultrasonic Sensors for Non-Destructive Testing and Structural Health Monitoring

Abstract

Bolted joints, as critical load-transferring components in large-scale equipment, require effective loosening monitoring to ensure structural safety. Vibro-acoustic modulation (VAM) has attracted considerable attention in bolt loosening monitoring due to its high sensitivity to contact-type defects, yet the influence of fundamental probe wave parameters remains insufficiently explored. In this paper, a theoretical relationship among the modulation amplitudes of the transmitted and reflected waves, the interface pressure, and the probe wave frequency was established based on contact acoustic nonlinearity (CAN) theory. Two complementary modulation indices, a logarithmic index and an integral-based index, were constructed, and systematic experiments on a bolted joint were conducted to analyze the influence of probe wave parameters. The results demonstrate that the logarithmic modulation index offers better stability than the integral-based one. A lower sweep rate is the primary factor in suppressing phase-induced background noise and improving the stability of the modulation index. While a wider swept-frequency range provides a more comprehensive response, it inherently increases the sweep rate under a fixed duration, leading to severe noise near the pump frequency. Therefore, optimizing the sweep rate is crucial for enhancing the identification accuracy of incipient bolt loosening. Theoretically, the frequency dependence is non-monotonic due to the stiffness-impedance balance, and an optimum frequency range exists. However, higher probe frequencies are inferred to induce a spatial focusing effect toward the central high-pressure zone, which significantly enhances the separation of modulation indices under different bolt torques. Moreover, the observed frequency-selective band (140–160kHz) is attributed to a local structural wave-trapping effect at the lap joint, which significantly amplifies the contact acoustic nonlinearity. By tuning the probe wave within this localized resonant band and controlling the sweep rate, the monitoring sensitivity is substantially improved, providing explicit practical guidelines for probe parameter selection.

Article Metrics

Citations

Article Access Statistics

Article metric data becomes available approximately 24 hours after publication online.