Skip to Content
SensorsSensors
  • This is an early access version, the complete PDF, HTML, and XML versions will be available soon.
  • Article
  • Open Access

9 September 2026

Multimode Fiber-Tip Interferometry for Time- and Frequency-Domain Analysis of Droplet Evaporation

,
,
,
,
and
1
INESC TEC—Institute for Systems and Computer Engineering, Technology and Science, Rua Dr. Roberto Frias, 4200-465 Porto, Portugal
2
FEUP—Faculty of Engineering of the University of Porto, Rua Dr. Roberto Frias, 4200-465 Porto, Portugal
*
Author to whom correspondence should be addressed.

Abstract

This work presents an experimental investigation of droplet evaporation dynamics using a step-index multimode fiber-tip (MMF) interferometer. Distilled water, ethanol, isopropyl alcohol (IPA), and their binary mixtures with water were analyzed through complementary frequency- and time-domain approaches. Fast Fourier Transform (FFT) analysis was used to identify the dominant spectral components over selected evaporation intervals, while the instantaneous phase obtained from the analytic signal was used to track time-dependent variations in the optical response. For water, dominant components at 8.34 and 9.87 Hz corresponded to thickness-variation rates of −4.85 and −5.75 µm/s, respectively. Ethanol exhibited a dominant component at 15.8 Hz, corresponding to −9.01 µm/s, whereas IPA showed components at 13.2 and 34.8 Hz, associated with rates of −7.46 and −19.6 µm/s. Binary mixtures exhibited multiple spectral components and stronger temporal variability, indicating a nonstationary optical response during evaporation. The frequency- and time-domain results therefore provide complementary descriptions: the FFT identifies the dominant components over the selected interval, whereas instantaneous-phase analysis reveals their temporal evolution. Because the analysis was performed over short, selected evaporation intervals, the refractive index was assumed to remain approximately constant, and the measured phase variations were therefore attributed predominantly to changes in droplet thickness. The retrieved values are consequently interpreted as thickness-variation rates rather than direct mass-loss rates. The proposed approach provides a simple and compact method for monitoring droplet evaporation.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.