Laser Processing and Thermophysical Characterization of Polymeric and Bio-Based Materials: Advances, Challenges, and Applications

Dear Colleagues,

In this Special Issue, we seek research or review articles that explore the laser cutting of wood and polymeric materials and the effects of heat generation, including the measurement of thermophysical properties. We encourage the submission of research that pertains to cutting kerf and heat-affected zone characterization, the measurement of surface roughness and the impact of laser cutting on wood colour changes. Moreover, materials suitable for laser cutting include polymers, wood-based materials and 3D-printed polymeric materials; we welcome studies that investigate the thermophysical properties of such materials, considering both anisotropy and the effects of moisture. Studies that discuss the impact of moisture content on the laser cutting of materials are particularly sought.

Acknowledgments:

Mr. Imants Adijans <imants.adijans@rtu.lv>

Dr. Ivan Ružiak
Guest Editor

Dr. Oguzhan Der
Guest Editor Assistant

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Materials is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.