Micro, Volume 2, Issue 1

The encapsulation of clove essential oil (CEO) in hydroxypropyl-β-cyclodextrin (HP-β-CD) and the subsequent incorporation of the inclusion complex in an elastic chitosan film in order to achieve a controlled release profile of the volatile...

Current commercially available in vitro skin models do not fully reproduce the structure and function of the native human skin, mainly due to their use of animal-derived collagen and their lack of a dynamic flow system. In this study, a full-thicknes...

Cu₂P₃I₂ wires were synthesized and converted to Ag₂P₃I₂ via post-synthetic modification. Single-wire and thin film devices were constructed from each material and evaluated as rapidly reversible humidity sensing semiconductors. All devices exhibited...

This study examines the preparation of several composites that are based on natural magnesium hydroxide (n-MDH) and various poly(ethylene-co-octene) polyolefin elastomers (POEs). Design of experiment (DoE) principles have been applied in order to opt...

This investigation is motivated by increasing interest in diamond and composite films for applications in biomedical and electronic devices. A biomimetic strategy is based on the use of commercial bile acids, such as ursodeoxycholic acid (UDCA) and h...

In the present work we report for the first time the carbonization of biomass waste, such as stale bread and spent coffee, in piranha solution (H₂SO₄-H₂O₂) at ambient conditions. Carbonization is fast and exothermic, resulting in the formation of car...

Microscale optofluidic devices are a category of microscale devices combining fluidic and optical features. These devices typically enable in-situ fluid flow measurement for pharmaceutical, environmental or biomedical applications. In micro-optofluid...

To utilize β-Ti based high temperature (HT) shape memory alloys (SMAs), a high Al concentration of 14 mol% was designed for sufficient suppressing the undesired ω-phase. HTSMA exhibits shape memory effect (SME) above 373 K, and thus the op...

Biosample analysis often requires the purification, separation, or fractionation of a biofluid prior to transport to the biosensor. Deterministic lateral displacement (DLD) is a size-based microfluidic separation technique that shows promise for bios...

Ge₂Sb₂Te₅ based devices attract the attention of researchers due to wide opportunities in designing phase change memory. Herein, we studied a possibility to fabricate periodic micro- and nanorelief at surfaces of Ge₂Sb₂Te₅ thin films on silicon oxide...

Conventional gloves partially insulate against heat transfer from a hot external environment. They also prevent metabolic heat generated by the human body from escaping. Thus, gloves are a source of heat buildup and heat stress in workers. Heat stres...

Analytic approximations are presented for the response of buckling-mode electrothermal actuators with very slender beams with a width-to-length ratio of $W/L\le 0.001$ of the type found in nanoelectromechanical systems (NEMS). The results are found as...

Wide band gap semiconductors such as silicon carbide (SiC) and gallium nitride (GaN) are excellent materials for the next generation of high-power and high-frequency electronic devices. In fact, their wide band gap (>3 eV) and high critical electr...

Over four decades ago, pulsed-laser melting, or pulsed-laser annealing as it was termed at that time, was the subject of intense study as a potential advance in silicon device processing. In particular, it was found that nanosecond laser melting of t...