Skip to Content
You are currently on the new version of our website. Access the old version .
NanomaterialsNanomaterials
  • Article
  • Open Access

23 February 2026

18 Pages

Effect of Substrate Bias on the Microstructure and Properties of CrAlSiN Composite Coatings

,
,
,
,
and
1
College of Mechanical Engineering, Chengdu University, Chengdu 610106, China
2
Chengdu Product Quality Inspection and Research Institute Co., Ltd., Chengdu 610200, China
*
Authors to whom correspondence should be addressed.

Abstract

CrAlSiN nanocomposite coatings with different structures were prepared by arc ion plating. The influence of substrate bias on the composition, microstructure and properties of the coating was investigated. The nanocomposite CrAlSiN coatings all had a fcc-(Cr, Al)N phase, where Al atoms and some Si atoms were solid-dissolved in CrN phase and some Si existed in the form of amorphous phase in the coating. The coatings were preferentially grown along the (200) crystal plane. With the increase in substrate bias, the roughness of the coating gradually decreased. When the substrate bias gradually increased to 100 V, the small particles aggregated into large particles, producing more holes, so that the surface roughness of the coating increased. At the same time, with the increase in substrate bias, the hardness and adhesion of the coating first increased and then decreased. When the substrate bias voltage was 80 V, the coating had the largest hard H (31.30 GPa), elastic modulus E* (432.15 GPa), H/E* (0.0724), H3/E*2 (0.1642) and binding force of 109.26 N.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.