Metals, Volume 6, Issue 5

This article investigates the effect of low-level ionizing radiation, namely X-rays, on the micro structural characteristics, resistance, and corrosion resistance of TIG-welded joints of AISI 304 austenitic stainless steel made using AISI 316L filler...

In this study, we comparatively investigate the low cycle fatigue behavior of Alloy 617 (INCONEL 617) weldments by gas tungsten arc welding process at room temperature and 800 °C in the air to support the qualification in high temperature application...

In this research, polyethylene terephthalate (PET), as a high-density thermoplastic sheet, and Aluminum A5052, as a metal with seven distinct surface roughnesses, were joined by friction spot welding (FSW). The effect of A5052’s various surface state...

This paper aims at studying the monotonic and cyclic plastic deformation behavior of DIN 34CrNiMo6 high strength steel. Monotonic and low-cycle fatigue tests are conducted in ambient air, at room temperature, using standard 8-mm diameter specimens. T...

For studying the influence of a bilateral slid rolling process (BSRP) on the surface integrity of a thin-walled aluminum alloy structure, and revealing the generation mechanism of residual stresses, a self-designed BSRP appliance was used to conduct...

The authors wish to make the following corrections to the citations in the published paper [1].[...]

Dissimilar diffusion bonds of TiAl alloy to AISI 310 stainless steel using Ni/Ti reactive multilayers were studied in this investigation. The Ni and Ti alternating layers were deposited by d.c. magnetron sputtering onto the base materials, with a bil...

This paper describes results of experimental research on the thin microhardened surface layer of a machined surface that occurs in materials using wire electrical discharge machining (WEDM) with brass wire electrode. The direct influence of microhard...