April 2011 - 30 articles
Cutting problem is one of the major problems faced in marble factories. Huge marble blocks coming from marble quarries are first cut into planes according to their depths. Then these planes are sized according to the length and width of the demanded...
Surface treatments of engineering materials are important for serviceable engineering components. One of the thermo-chemical surface treatments of steel based materials is the boriding process. In this study, low alloy steel substrates were borided b...
In this study, the stress analysis of YBCO/CeO2/YSZ/CeO2/Ni architextured materials under cryogenic conditions was carried out for coated conductor applications. YBCO/CeO2/YSZ/CeO2 multilayer films were fabricated on Ni tape substrate using reel-to-r...
The scope of this study is to find out yield curve on the coating-substrate system of hydroxyapatite (HA) by finite element modeling. With this regard, Hydroxyapatite (HA) coatings were successfully formed on Ti6Al4V substrates by using biomimetic te...
Stress concentration at the corner bends of an anti-roll bar that is designed for an intercity passenger bus is reduced by optimising the shape of the critical regions. In order to do this, parameters which constitute the geometry of the stress conce...
This paper examines the failures and strengths of joints bonded by a Neoxil CE92 N8 adhesive at different overlap lengths and different taper angles. The study was carried out both as experimental and numerical. In the experimental stage, lap-shear t...
In this study, the dynamic behaviour of a beam carrying accelerating mass is investigated. A MATLAB code was developed for numerical solutions. The accelerating moving mass that is travelling on the beam was modelled as a moving finite element in ord...
The least well known loading type is the impact loading that are affecting on to RC structures. Several impact tests have been used to demonstrate the relative brittleness and impact resistance of concrete and similar construction materials. However,...
It is essential that joints in the design of aluminium based materials be safe and at the desired strength. Specific methods are to be used in welding of these materials. Brazing, that assures joining without changing the material properties, is wide...
In this study, nonlinear transverse vibrations of a tensioned Euler-Bernoulli beam resting on multiple supports are investigated. The immovable end conditions due to simple supports cause stretching of neutral axis and introduce cubic nonlinearity to...
of 3
Get Alerted
Add your email address to receive forthcoming issues of this journal.
