Skip to Content
You are currently on the new version of our website. Access the old version .
ChemosensorsChemosensors
  • Article
  • Open Access

9 September 2022

15 Pages

Spinel Magnesium Ferrite (MgFe2O4): A Glycine-Assisted Colloidal Combustion and Its Potentiality in Gas-Sensing Application

,
,
,
,
,
and
1
School of Physical Sciences, Punyashlok Ahilyadevi Holkar Solapur University, Solapur 413255, India
2
Department of Chemistry, Faculty of Science and Arts and Promising Centre for Sensors and Electronic Devices (PCSED), Najran University, Najran 11001, Saudi Arabia
3
Department of Materials Science and Engineering, The Ohio State University, Columbus, OH 43210, USA
4
Department of Physics, Santosh Bhimrao Patil College, Mandrup, Solapur 413221, India

Abstract

Herein, we describe the facile synthesis of spinel MgFe2O4 ferrite and its potential use as a gas sensor using a straightforward and reliable sol–gel approach, i.e., the glycine-assisted auto-combustion route. The novelty in obtaining the sensing material via the auto-combustion route is its inherent simplicity and capability to produce the material at an industry scale. The said cost-effective process makes use of simple metal salts (Mg and Fe-nitrates) and glycine in an aqueous solution, which leads to the formation of spinel MgFe2O4 ferrite. A single-phase crystallinity with crystallite sizes ranging between 36 and 41 nm was observed for the synthesized materials using the X-ray diffraction (XRD) technique. The porous morphologies of the synthesized materials caused by auto-ignition during the combustion process were validated by the microscopic investigations. The EDS analysis confirmed the constituted elements such as Mg, Fe, and O, without any impurity peaks. The gas-sensing ability of the synthesized ferrites was examined to detect various reducing gases such as LPG, ethanol, acetone, and ammonia. The ferrite showed the highest response (>80%) toward LPG with the response and recovery times of 15 s and 23 s, respectively. Though the sensor responded low toward ammonia (~30%), its response and recovery times were very quick, i.e., 7 s and 9 s, respectively. The present investigation revealed that the synthesized ferrite materials are good candidates for fabricating high-performance sensors for reducing gases in real-world applications.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.