Next Article in Journal
Writing Tiny Nanoclusters Using a Nanofountain Pen Operated by Spontaneous Evaporation
Previous Article in Journal
Research on the Input-Transformation-Output Process of Additive Manufacturing: Comparing PLA/Polysmooth and Resin Printed Rings
Previous Article in Special Issue
Indentation Size Effect in Electrodeposited Nickel with Different Grain Size and Crystal Orientation
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Correction

Correction: Zhang et al. Microstructures, Mechanical Properties and Transformation Behavior in Ni49.6Ti35.4Hf15 Alloy Produced with High-Pressure Torsion. Crystals 2023, 13, 1246

1
School of Materials Science and Engineering, Northeastern University, Shenyang 110819, China
2
Key Laboratory of Light Structural Materials of Liaoning Province, Northeastern University, Shenyang 110819, China
3
Department of Design and Engineering, Faculty of Science and Technology, Bournemouth University, Poole, Dorset BH12 5BB, UK
4
Materials Research Group, Department of Mechanical Engineering, University of Southampton, Southampton SO17 1BJ, UK
*
Authors to whom correspondence should be addressed.
Crystals 2024, 14(1), 8; https://doi.org/10.3390/cryst14010008
Submission received: 8 December 2023 / Accepted: 11 December 2023 / Published: 21 December 2023
(This article belongs to the Special Issue Crystal Plasticity (Volume III))

Error in Equation

In the original publication [1], there was a mistake in Equation (2) as published. Due to a typing error, an extra “=” was added. The corrected Equation (2) appears below. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.
ε = 2 3 l n ( γ 2 + 1 + γ 2 4 )

Reference

  1. Zhang, J.; Wang, S.; Ding, H.; Hu, P.; Huang, Y.; Zhang, Y. Microstructures, Mechanical Properties and Transformation Behavior in Ni49.6Ti35.4Hf15 Alloy Produced with High-Pressure Torsion. Crystals 2023, 13, 1246. [Google Scholar] [CrossRef]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

Share and Cite

MDPI and ACS Style

Zhang, J.; Wang, S.; Ding, H.; Hu, P.; Huang, Y.; Zhang, Y. Correction: Zhang et al. Microstructures, Mechanical Properties and Transformation Behavior in Ni49.6Ti35.4Hf15 Alloy Produced with High-Pressure Torsion. Crystals 2023, 13, 1246. Crystals 2024, 14, 8. https://doi.org/10.3390/cryst14010008

AMA Style

Zhang J, Wang S, Ding H, Hu P, Huang Y, Zhang Y. Correction: Zhang et al. Microstructures, Mechanical Properties and Transformation Behavior in Ni49.6Ti35.4Hf15 Alloy Produced with High-Pressure Torsion. Crystals 2023, 13, 1246. Crystals. 2024; 14(1):8. https://doi.org/10.3390/cryst14010008

Chicago/Turabian Style

Zhang, Jintao, Shibo Wang, Hua Ding, Peng Hu, Yi Huang, and Yu Zhang. 2024. "Correction: Zhang et al. Microstructures, Mechanical Properties and Transformation Behavior in Ni49.6Ti35.4Hf15 Alloy Produced with High-Pressure Torsion. Crystals 2023, 13, 1246" Crystals 14, no. 1: 8. https://doi.org/10.3390/cryst14010008

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop