You are currently viewing a new version of our website. To view the old version click .
Proceedings
  • Abstract
  • Open Access

28 May 2024

A Mitigating Strategy for Urban Heat Islands: The Biomimicry Approach Case of Delhi †

,
,
,
and
Department of Architecture, School of Planning & Architecture, New Delhi 110002, India
*
Author to whom correspondence should be addressed.
Presented at the 1st International Online Conference on Biomimetics (IOCB 2024), 15–17 May 2024; Available online: https://sciforum.net/event/IOCB2024.
This article belongs to the Proceedings The 1st International Online Conference on Biomimetics
The need for widespread urbanisation has increased due to population growth. Because of this, there is now a phenomena called urban heat islands (UHIs), which form when there are greater air levels or surface temperatures in urban areas than in rural areas. The local climate, the urban fabric, the materials used, and the surfaces all contribute to UHIs. Architects found that with every 0.6 °C increase in midsummer temperature, peak hour power demand climbs 1.5 to 2% in Delhi. It has been projected that for every degree over a (locally specified) cut-off point, mortality rates for populations inside the European Union increase by 1 to 4%. However, in the middle of the hot buildings and humid streets, nature provides us with a multitude of clever cooling strategies that we might imitate. A creative approach to problem solving, bioinspiration, also called biomimicry, draws inspiration from nature to develop and innovate across a range of industries. It offers pleasing aesthetics in addition to useful solutions. A few of the bioinspired techniques include using materials with high reflectance, i.e., those which are similar to the skin of Saharan ants; imitating the colour and reflectance variations of zebra skin for differential heating; and adding water features and vegetation that are modelled after human skin’s evapotranspiration. Quite a few architectural components use these biomimetic concepts. Sun protection is actively provided by kinetic facades. Albedo is increased by the use of materials with high reflectivity. Differential heating caused by the incorporation of materials with varying degrees of reflectance creates convection currents. A localised cooling effect is achieved by the interspersion of green walls, water features, and porous materials that retain water. The goal of this study is to develop sustainable urban environments with lower UHI impacts using biomimetic concepts, such as green infrastructure and bioinspired materials.

Supplementary Materials

The following supporting information can be downloaded at: https://www.mdpi.com/article/10.3390/proceedings2024107005/s1.

Author Contributions

A.D.: conceptualization, methodology, visualization, formal analysis, writing—original draft. A.K.: resources, visualization, formal analysis, writing—review & editing. N.B.: resources, visualization, formal analysis, writing—review & editing. S.K.: resources, visualization, formal analysis, writing—review & editing. A.K.J.: resources, visualization, formal analysis, writing—review & editing, supervision. All authors have read and agreed to the published version of the manuscript.

Funding

This research received no external funding.

Institutional Review Board Statement

Not applicable.

Data Availability Statement

No new data were created or analyzed in this study.

Conflicts of Interest

The authors declare no conflict of interest.
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.