Next Article in Journal
Permeability Measurements of 3D Microstructures Generated by Phase Field Simulation of the Solidification of an Al-Si Alloy during Chill Casting
Next Article in Special Issue
Microstructural Stability of the CoCrFe2Ni2 High Entropy Alloys with Additions of Cu and Mo
Previous Article in Journal
In Situ Evaluation of the Influence of Interstitial Oxygen on the Elastic Modulus of La2NiO4
Previous Article in Special Issue
Composition Stability and Cr-Rich Phase Formation in W-Cr-Y and W-Cr-Ti Smart Alloys
 
 
Article

High-Temperature Surface Oxide Growth Kinetics of Al–Si–Zr Bulk Alloys and Ribbons

1
Department of Chemical Sciences, Faculty of Pharmacy, Medical University of Plovdiv, 15A Vassil Aprilov blvd., 4000 Plovdiv, Bulgaria
2
Department of General and Inorganic Chemistry, Methodology of Chemical Education, University of Plovdiv Paisii Hilendarski, 4000 Plovdiv, Bulgaria
3
Acad. A. Balevski Institute of Materials Science, BAS, 1574 Sofia, Bulgaria
*
Author to whom correspondence should be addressed.
Academic Editor: Isaac Toda-Caraballo
Metals 2021, 11(12), 1893; https://doi.org/10.3390/met11121893
Received: 2 November 2021 / Revised: 17 November 2021 / Accepted: 23 November 2021 / Published: 25 November 2021
A typical modification technique of the functional properties of Al–Si based alloys is the addition of some third element in trace level. In the present work, ternary Al–Si–Zr bulk and ribbon alloys have been prepared. The kinetics of high-temperature surface oxidation has been studied by thermogravimetric method. It was found that at the start of the experiment the chemical reaction velocity is rate-controlling while for longer times the (oxygen) diffusion is the rate-controlling process. Activation energy of the two stages of oxidation has been obtained. Additional studies such as thermochemical analysis, optical and electron microscopy, and microhardness tests have been done. View Full-Text
Keywords: Al–Si–Zr bulk alloys and rapidly solidified ribbons; thermochemical and thermogravimetric analysis; kinetics of high-temperature oxidation Al–Si–Zr bulk alloys and rapidly solidified ribbons; thermochemical and thermogravimetric analysis; kinetics of high-temperature oxidation
Show Figures

Figure 1

MDPI and ACS Style

Kiradzhiyska, D.; Vassilev, G.; Mancheva, R.; Yaneva, S.; Milcheva, N. High-Temperature Surface Oxide Growth Kinetics of Al–Si–Zr Bulk Alloys and Ribbons. Metals 2021, 11, 1893. https://doi.org/10.3390/met11121893

AMA Style

Kiradzhiyska D, Vassilev G, Mancheva R, Yaneva S, Milcheva N. High-Temperature Surface Oxide Growth Kinetics of Al–Si–Zr Bulk Alloys and Ribbons. Metals. 2021; 11(12):1893. https://doi.org/10.3390/met11121893

Chicago/Turabian Style

Kiradzhiyska, Denitsa, Gueorgui Vassilev, Rositsa Mancheva, Svetlana Yaneva, and Nikolina Milcheva. 2021. "High-Temperature Surface Oxide Growth Kinetics of Al–Si–Zr Bulk Alloys and Ribbons" Metals 11, no. 12: 1893. https://doi.org/10.3390/met11121893

Find Other Styles
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Article Access Map by Country/Region

1
Back to TopTop