Search Results (10)

Background/Objectives: Most brain magnetic resonance imaging (MRI) is performed in supine position, although posture may influence cerebrovascular signal characteristics through gravity-related physiological changes. However, posture-dependent vascular signal alterations on low-field MRI have not been sufficiently quantified. This study aimed to quantify posture-related internal carotid artery (ICA) signal alterations using low-field MRI by comparing seated and supine images with intensity-, noise-, and texture-based metrics. Methods: Nine healthy adults (20–69 years old; one female) underwent 0.25 T tilting MRI in supine and seated postures. 3D gradient echo T1-weighted images were obtained. The bilateral ICA regions of interest (ROI) and adjacent reference ROI were manually delineated. The signal-to-noise ratio (SNR), contrast-to-noise ratio (CNR), signal intensity ratio (SIR), gray-level co-occurrence matrix (GLCM) texture features (contrast, correlation, energy, and homogeneity) were extracted and compared between postures using Wilcoxon signed-rank tests. Results: Seated posture produced significantly higher ICA signal intensity metrics than the supine posture, with increased SNR (median 17.11 vs. 13.48), CNR (median 21.94 vs. 18.36), and SIR (median 10.84 vs. 9.54) (p = 0.004). GLCM texture analysis demonstrated a significant decrease in contrast in the seated position (median 62.01 vs. 145.92; p = 0.004), whereas correlation, energy, and homogeneity showed no significant between-posture differences. Conclusions: Low-field MRI was sensitive to posture-dependent ICA signal alterations. ICA-based metrics may provide quantitative markers of gravity-related cerebrovascular adaptation. Full article

To investigate the influence of external ambient temperature on the transmission characteristics of laser propagation in an internal channel, a simulation model of laser transmission within a closed channel is established in this study. The model comprehensively considers factors including gas density, refractive index distribution, and thermal deformation of optical components. Based on optical transmission theory, the model is used to calculate the beam drift characteristics and the variation in the Strehl ratio at different temperatures. The results indicate that ambient temperature has a significant impact on beam stability and quality. At low temperature (−30 °C), speckle structures appear in the laser spot, with minor drift along the X direction but obvious negative drift along the Y direction, mainly caused by the sinking of cold air driven by gravity and the refractive index gradient. The beam drift decreases initially with increasing temperature, reaches its minimum at around 10 °C, and then increases gradually as the temperature continues to rise. The Strehl ratio initially increases during the early stage of temperature rise, but diminishes in the high-temperature range due to intensified gas disturbances, enhanced thermal lensing effects, and aggravated mirror surface deformation. Full article

To address pressure-drop-induced safety risks in high-drop gravity-fed irrigation pipelines, this study investigates coordinated prevention and control strategies that integrate air release and vacuum valve groups with flow-adaptive valve closure rules. A large-scale self-pressurized irrigation network (1.33 × 10⁸ m²) in Karamay, Xinjiang, China, is selected as a representative case study. Based on one-dimensional transient flow modeling, pressure drop and negative-pressure characteristics induced by inlet valve closure in the main pipeline are analyzed using wave speed theory, governing differential equations, and the finite difference method. A coordinated protection framework is proposed that explicitly links valve operating patterns with the spatial configuration of protective devices. Unlike conventional schemes that rely on empirical layouts and fixed closure rules, this study introduces a critical-flow-velocity-based valve grouping method combined with flow-dependent valve closure strategies. Simulation results demonstrate that a strategically optimized configuration of air release and vacuum valves along the main pipeline is sufficient to eliminate negative pressure under all operating conditions. For flow rates below 6 m³/s, linear valve closure ensures safe operation, whereas a two-stage closure is required for higher flow rates (6–10 m³/s). As flow increases, reducing the fast-closure ratio and extending the total closure time effectively suppress pressure-drop-dominated transient effects at vulnerable inlet sections. By effectively mitigating transient pressure surges, the proposed coordinated “valve closure-protection device” strategy improves system adaptability to flow variability and provides practical engineering guidance for the safe operation of gravity irrigation systems, particularly high-gradient self-pressurized networks. Full article

Sadi Carnot’s seminal work laid the foundation for exploring the effects of thermodynamics across diverse domains of physics, stretching from quantum to cosmological scales. Here, we build on the principles of the original Carnot heat engine, and apply it in the context of a particular toy model black brane. This theoretical construct of an effectively two-dimensional, stable, and stationary gravitational object in four-dimensional spacetime derives from a hypothetical flat planet collapsed under the influence of gravity. By constructing a thermodynamic cycle involving three such black branes, we explore the possibility of energy extraction or mining, driven by the temperature gradients and gravitational potential differences characteristic of curved spacetime. Analytic solutions obtainable within this toy model illuminate key aspects of black hole thermodynamics in general, particularly for spacetimes that are not asymptotically flat. Central to these findings is the relation between gravitationally induced temperature ratios and entropy changes, which collectively offer a novel perspective on obtainable energy transfer processes around gravitational structures. This analysis highlights potential implications for understanding energy dynamics in gravitational systems in general, including for black hole evaporation and experimentally implemented black hole analogues. The presented findings not only emphasise the universality of the thermodynamic principles first uncovered by Carnot, but also suggest future research directions in gravitational thermodynamics. Full article

In Cartesian coordinates $\left(x,y,z\right),$ the gradient Richardson number $Ri$ is the ratio between the square of the buoyancy frequency N and the square of the vertical shear S, $Ri=N^2/S^2$, where $N^2=-\left(g/\rho \right)\partial \rho /\partial z$ and $S^2={\left(\partial u/\partial z\right)}^2+{\left(\partial v/\partial z\right)}^2$, with ρ potential density, $\left(u,v\right)$ the horizontal velocity components and g gravity acceleration. In isopycnic coordinates $\left(x,y,\rho \right)$, $Ri$ is expressed as the ratio between ${M^2\equiv N}^{-2}$ and the squared diapycnal shear ${S_{\rho }}^2={\left(\rho /g\right)}^2\left[{\left(\partial u/\partial \rho \right)}^2+{\left(\partial v/\partial \rho \right)}^2\right]$, $Ri=M^2/{S_{\rho }}^2$. This could suggest that a decrease (increase) in stratification brings a decrease (increase) in dynamic stability in Cartesian coordinates, but a stability increase (decrease) in isopycnic coordinates. The apparently different role of stratification arises because S and $S_{\rho }$ are related through the stratification itself, $S_{\rho }=S/N^2$. In terms of characteristic times, this is equivalent to $\tau \equiv S_{\rho }={t_o}^2/t_d$, which is interpreted as a critical dynamic time $\tau$ that equals the buoyancy period $t_o\equiv N^{-1}$ normalized by the ratio $t_d/t_o$, where $t_d=S^{-1}$ is the deformation time. Here we follow simple arguments and use field data from three different regions (island shelf break, Gulf Stream and Mediterranean outflow) to endorse the usefulness of the isopycnal approach. In particular, we define the reduced squared diapycnal shear ${{\sigma }_{\rho }}^2={S_{\rho }}^2-M^2$ and compare it with the reduced squared vertical ${\sigma }^2=S^2-N^2$, both being positive (negative) for unstable (stable) conditions. While both Ri and ${\sigma }^2$ remain highly variable for all stratification conditions, the mean ${{\sigma }_{\rho }}^2$ values approach ${S_{\rho }}^2$ with increasing stratification. Further, the field data follow the relation ${{\sigma }_{\rho }}^2=\left(1-Ri\right)/\left(N^{2}Ri\right)$, with a subcritical $Ri=0.22$ for both the island shelf break and the Mediterranean outflow. We propose ${{\sigma }_{\rho }}^2$ and ${S_{\rho }}^2$ to be good indexes for the occurrence of effective mixing under highly stratified conditions. Full article

This experimental study aims to investigate the characteristics of turbulent flow in channels with vegetated banks and varying channel width under the condition of the incipient motion of bed material. The natural reeds were used as emergent vegetation on the sidewalls of a laboratory flume. In total, nine experimental runs have been conducted with different experimental setups by using three different particle sizes of bed material and three different channel bed slopes. An Acoustic Doppler velocimetry (ADV) was used to acquire velocity components in three directions. The results of this study indicate that the streamwise velocities have the maximum and minimum values at the cross sections with the narrowest and widest width, respectively. When the aspect ratio is less than 5, the maximum velocity occurs below the water surface, due to presence of the secondary currents. It is found that, at all measurement points, the distribution of the Reynolds shear stress has a Z-shaped profile owing to presence of vegetation on the channel sidewalls. By extrapolating the profiles for flow velocity and Reynolds shear stress towards the surface of the channel bed, the near-bed incipient velocities and the corresponding shear stresses for the incipient motion have been determined. By increasing the channel bed slope, the estimated near-bed parameters for all particle sizes decreased, indicating the dominance of the gravity effect over the pressure gradient effect. It was also observed that the Shields method was invalid for assessing the incipient motion of bed material in the presence of vegetation on the sidewalls of a channel that has a varying width. Full article

Underwater gravity gradient detection techniques are conducive to ensuring the safety of submersible sailing. In order to improve the accuracy of underwater obstacle detection based on gravity gradient detection technology, this paper studies the gravity gradient underwater obstacle detection method based on the combined support vector regression (SVR) algorithm. First, the gravity gradient difference ratio (GGDR) equation, which is only related to the obstacle’s position, is obtained based on the gravity gradient equation by using the difference and ratio methods. Aiming at solving the shortcomings of the GGDR equation based on Newton–Raphson method (NRM), combined with SVR algorithm, a novel SVR–gravity gradient joint method (SGJM) is proposed. Second, the differential ratio dataset is constructed by simulating the gravity gradient data generated by obstacles, and the obstacle location model is trained using SVR. Four measuring lines were selected to verify the SVR-based positioning model. The verification results show that the mean absolute error of the new method in the x, y, and z directions is less than 5.39 m, the root-mean-square error is less than 7.58 m, and the relative error is less than 4% at a distance of less than 500 m. These evaluation metrics validate the reliability of the novel SGJM-based detection of underwater obstacles. Third, comparative experiments based on the novel SGJM and traditional NRM were carried out. The experimental results show that the positioning accuracy of x and z directions in the obstacle’s position calculation based on the novel SGJM is improved by 88% and 85%, respectively. Full article

What is nucleation core origin during alloy solidification, especially for equiaxed grains? Different dependence degrees of the magnitude or occurrence of element content variation could shed light on this long-standing issue in actual large ingots. Here, based on etched surface height and grayscale, element content distributions within the solid fraction in continuous casting billets and additive manufacturing samples are first obtained by only a two-dimensional surface. Then, combined with the phylogenetic trees, the rank correlation is applied to measure the dependence of content differences during initial solidification. Assessments of external dependence degrees are helpful to determine nucleation core origin and low internal dependence degree facilitates grain refinement. Moreover, in continuous casting, some nucleation cores in the central equiaxed grain zone are confirmed to originate from the edge-chilled zone and high equiaxed grain area ratio under a low superheat, which is attributed to the low ratio of temperature gradient to growth rate rather than remelting fewer cores originating from the chilled zone. In addition, the floating behavior of separated grains originating from the chilled zone can be affected by gravity force, but these grains should be more active when increasing the casting superheat that may weaken the influence of gravity to a certain extent. Full article

In this paper, we construct a new 1′ $\times$ 1′ global seafloor topography model, BAT_VGG2021, using the satellite altimetric vertical gravity gradient anomaly model (VGG), SIO curv_30.1.nc, and ship soundings. Approximately 74.66 million single-beam depths and more than 180 GB of multibeam grids were downloaded and adopted from the National Centers for Environmental Information (NCEI), Japan Agency for Marine-Earth Science and Technology (JAMSTEC), and Geosciences Australia (GA). The SIO curv_30.1.nc model was used to predict seafloor topography at 15~160 km wavelengths, and ship soundings were used to calibrate topography to VGG ratios. The accuracy of the new BAT_VGG2021 model was assessed by comparing it with ship soundings and existing models. The results indicate that the standard deviation of differences between the predicted model and ship soundings is about 40~80 m, and ~93% of the differences are within 100 m, similar to that of the SIO topo_20.1.nc model. The new BAT_VGG2021 model shows better accuracy than the DTU18BAT, ETOPO1, and GEBCO_08 models, and has been improved significantly from our last model, BAT_VGG2014. Full article

The aim of this research was to analyze the horizontal spatial heterogeneity of both water and superficial sediment quality among and within the reservoirs of the Cantareira System (CS), focusing on concentrations of N and P, attributed to the dumping of raw domestic sewage into water bodies, which is the main cause of water pollution in São Paulo State (Brazil). The CS is a multi-system complex composed of five interconnected reservoirs, with water transported by gravity through 48 km of tunnels and channels. From the last reservoir of the CS, with an output of 33 m³ s⁻¹, the water is conducted to a water treatment plant, producing half of the water consumed by 19 million people inhabiting São Paulo city. The upstream reservoirs are more eutrophic than the downstream ones. Data also suggest that the low phytoplankton biomass (ranging from 0.9 to 14.4 μg dm⁻³) is regulated by the low nutrient availability, mainly of phosphorus (TP ranging from below the detection limit, <9.0 μg dm⁻³, to 47.3 μg dm⁻³). For water, the DIN/TP ratios values range from 19 to 380. The upstream reservoirs function as nutrient accumulators and the sediment is the main compartment in which P and N are stored. Although the reservoirs are located in different river basins and are not in sequence along the same river, the results suggest a marked gradient between the reservoirs, with features similar to those of cascade reservoirs. The large volumes flowing through the canals and tunnels could explain the observed pattern. The CS reservoirs can therefore be considered multi-system reservoirs in cascade, constituting a particular case of multi-system reservoirs. Full article