Incorrect Materials and Methods
The authors wishe to make the following corrections to this paper [1]:
In the fourth paragraph of the Materials and Methods Section, (1) in the second sentence, replace “2.5 mm thickness” with “2 mm thickness”; (2) in the third sentence, replace “120 s” with “10 s”; (3) in the fourth sentence, delete “, followed by light polymerization for another 15 s”; (4) delete the last two duplicated sentences, “The silicone mold was gently sectioned using a scalpel, and excess composite material was removed, followed by light polymerization for another 15 s. The specimens were then stored in distilled water at room temperature for 24 h before the SBS test.”
The authors would like to apologize for any inconvenience caused to the readers by these changes and state that the scientific conclusions are unaffected. The original publication has also been updated.
Reference
- Alnafaiy, S.; Labban, N.; Maawadh, A.; Alshehri, H.; Albaijan, R. Repair bond strength of composite resin to aged resin and glass-matrix CAD/CAM ceramic materials using two different repair systems. Coatings 2021, 11, 1331. [Google Scholar] [CrossRef]
Publisher’s Note: MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations. |
© 2022 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).