Correction: Li, P., et al. Research on Erosion-Corrosion Rate of 304 Stainless Steel in Acidic Slurry via Experimental Design Method. Materials 2019, 12, 2330

Ping Li; Yanjie Zhao; Libo Wang

doi:10.3390/ma12193181

,

and

¹

Henan Key Laboratory of Materials on Deep-Earth Engineering, School of Materials Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China

²

State Key Laboratory of Solid Lubrication, Lanzhou Institute of Chemical Physics, Chinese Academy of Sciences, Lanzhou 730000, China

³

Henan International Joint Research Laboratory for High-Performance Light Metallic Materials and Numerical Simulations, Jiaozuo 454000, China

^*

Author to whom correspondence should be addressed.

Materials2019, 12(19), 3181;https://doi.org/10.3390/ma12193181

Version Notes

Order Reprints

The authors wish to make the following corrections to this paper [1]:

We found an error in 2.3. Experimental Methodology, i.e., on page 4 of 11, lines 19–20, where the sentence “The average size and mass fraction of the sands were 20~40 mesh and 10%” should be “The average size and mass fraction of the sands were 20~40 mesh and 5%”.

The authors would like to apologize for any inconvenience caused to the readers by this change.

Reference

Li, P.; Zhao, Y.; Wang, L. Research on Erosion-Corrosion Rate of 304 Stainless Steel in Acidic Slurry via Experimental Design Method. Materials 2019, 12, 2330. [Google Scholar] [CrossRef] [PubMed]

© 2019 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).

Correction: Li, P., et al. Research on Erosion-Corrosion Rate of 304 Stainless Steel in Acidic Slurry via Experimental Design Method. Materials 2019, 12, 2330

Reference

Article Metrics

Citations

Article Access Statistics