Additive Manufacturing of Metallic Alloys and Composites
A special issue of Processes (ISSN 2227-9717). This special issue belongs to the section "Manufacturing Processes and Systems".
Deadline for manuscript submissions: closed (15 May 2023) | Viewed by 1766
Special Issue Editors
Interests: advanced manufacturing; machining aerospace structural materials; characterization of materials; optimization
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Additive manufacturing (AM), being a disruptive technology, has affected the manufacturing paradigm to a great extent. The main advantage of AM is the minimum tooling required, along with the high buy-to-fly ratio, due to the addition of layers that waste less raw material, contrary to removing the material from a block to produce a part. Consequently, the cost of the fabricated parts and lead time has significantly declined with the enhanced buy-to-fly ratio. Moreover, this technology is very suitable for the smaller lot production in prototyping the new part design validation in automotive, aerospace, and biomedical engineering sectors. There are various techniques involved in additive manufacturing, such as binder jetting and selective laser sintering, employed for the 3D printing of metals. The main challenge is to formularize the materials system that shall be compatible with each other and provide a cost-effective solution in terms of raw materials, processing, and operations cost. Moreover, the components produced will have higher-quality features, such as mechanical performance, meeting dimensional requirements and a better surface finish.
This Special Issue focuses on the materials system development and processes for metallic and composite additive manufacturing; however, topics in other 3D printing technologies and the AM of composite materials, such as fiber-reinforced polymers (FRPs), are also welcomed.
Dr. Muhammad Aamir
Dr. Israr Ud Din
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Processes is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- additive manufacturing
- metals and alloys
- composites
- characterization
- properties
- processes
