energies-logo

Journal Browser

Journal Browser

Hydraulic Fracture Stimulation for the Exploitation of Unconventional Resources in Worldwide

A special issue of Energies (ISSN 1996-1073).

Deadline for manuscript submissions: closed (15 November 2016) | Viewed by 22026

Special Issue Editor


E-Mail Website
Guest Editor
Petroleum Engineering Discipline, WA School of Mines: Minerals, Energy and Chemical Engineering, Curtin University, Perth, WA 6102, Australia
Interests: hydraulic fracturing; drilling and completion engineering; petroleum production engineering
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

This Special Issue focuses on state-of-the-art and recent advances in Hydraulic Fracture Stimulation for the exploitation of unconventional resources, such as tight gas, shale gas, shale oil and coal seam gas with an emphasis on three main aspects:

  • Geomechanics Aspects—Mechanics of Hydraulic Fracturing—Hydraulic Fracture initiation, propagation, and interaction of natural and hydraulic fracture, Hydraulic Fracture diagnosis and monitoring; and fluid flow, numerical simulation and experimental studies
  • Reservoir Engineering aspects with emphasis on unconventional reservoir: Reservoir Modelling and Simulation, Production Performance Analysis, Rate Transient Analysis; Stimulated Reservoir Volume (SRV), Formation Damage due to Fracturing
  • Design and Construction of Hydraulic Fractured Well—Drilling, Completion, Wellbore Integrity

Prof. Mofazzal Hossain
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Energies is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • hydraulic fracture
  • well stimulation
  • unconventional resources
  • shale gas
  • tight gas
  • fracture initiation
  • fracture propagation
  • interaction of natural and hydraulic fracture
  • solid and fluid interaction
  • rate transient analysis (RTA)
  • special well test analysis for hydraulic fractured well
  • well completion
  • wellbore integrity
  • hydraulic fracture diagnosis and monitoring
  • fluid flow through hydraulic and natural fracture
  • formation damage due to fracturing
  • fracturing fluids

Published Papers (4 papers)

Order results
Result details
Select all
Export citation of selected articles as:

Research

5466 KiB  
Article
Near Wellbore Hydraulic Fracture Propagation from Perforations in Tight Rocks: The Roles of Fracturing Fluid Viscosity and Injection Rate
by Seyed Hassan Fallahzadeh, Md Mofazzal Hossain, Ashton James Cornwell and Vamegh Rasouli
Energies 2017, 10(3), 359; https://doi.org/10.3390/en10030359 - 14 Mar 2017
Cited by 43 | Viewed by 5433
Abstract
Hydraulic fracture initiation and near wellbore propagation is governed by complex failure mechanisms, especially in cased perforated wellbores. Various parameters affect such mechanisms, including fracturing fluid viscosity and injection rate. In this study, three different fracturing fluids with viscosities ranging from 20 to [...] Read more.
Hydraulic fracture initiation and near wellbore propagation is governed by complex failure mechanisms, especially in cased perforated wellbores. Various parameters affect such mechanisms, including fracturing fluid viscosity and injection rate. In this study, three different fracturing fluids with viscosities ranging from 20 to 600 Pa.s were used to investigate the effects of varying fracturing fluid viscosities and fluid injection rates on the fracturing mechanisms. Hydraulic fracturing tests were conducted in cased perforated boreholes made in tight 150 mm synthetic cubic samples. A true tri-axial stress cell was used to simulate real far field stress conditions. In addition, dimensional analyses were performed to correspond the results of lab experiments to field-scale operations. The results indicated that by increasing the fracturing fluid viscosity and injection rate, the fracturing energy increased, and consequently, higher fracturing pressures were observed. However, when the fracturing energy was transferred to a borehole at a faster rate, the fracture initiation angle also increased. This resulted in more curved fracture planes. Accordingly, a new parameter, called fracturing power, was introduced to relate fracture geometry to fluid viscosity and injection rate. Furthermore, it was observed that the presence of casing in the wellbore impacted the stress distribution around the casing in such a way that the fracture propagation deviated from the wellbore vicinity. Full article
Show Figures

Figure 1

8624 KiB  
Article
Numerical Investigation of the Time-Dependent and the Proppant Dominated Stress Shadow Effects in a Transverse Multiple Fracture System and Optimization
by Lei Zhou, Junchao Chen, Yang Gou and Wentao Feng
Energies 2017, 10(1), 83; https://doi.org/10.3390/en10010083 - 11 Jan 2017
Cited by 12 | Viewed by 4769
Abstract
In this paper, a numerical study is conducted to investigate the stress shadow effects (stress reorientation and change) during hydraulic fracturing in a transverse multiple fracture system. A numerical model is used for the numerical study. It is a 3D model and can [...] Read more.
In this paper, a numerical study is conducted to investigate the stress shadow effects (stress reorientation and change) during hydraulic fracturing in a transverse multiple fracture system. A numerical model is used for the numerical study. It is a 3D model and can simulate the fracture operation from injection begin to full closure (fracture contact). Therefore, there is no need to assume the fracture geometry for the investigation of the stress shadow effects (unlike previous studies). In the numerical study, the first and second operations in a fictive transverse multiple fracture system are simulated, meanwhile the stress shadow effects and their influences on the propagation and proppant placement of the second fracture are investigated. According to the results, the following conclusions are discerned: (1) most proppants are located in the lower part of the reservoir, even below the perforation; (2) the stress shadow effects are time-dependent and proppant dominated; (3) the stress shadow effects affect the fracture propagation and the proppant placement of the second fracture, and also the fracture conductivity of the first fracture; (4) the time-dependent stress shadow effects can be divided into four phases, fracture enlargement, closure without proppant contact, closure with proppant contact and full closure; and (5) the superposition effect of the stress shadow in a transverse multiple fracture system exists. According to the conclusions, some optimizations are recommended. Full article
Show Figures

Figure 1

901 KiB  
Article
Numerical Simulation of the Propagation of Hydraulic and Natural Fracture Using Dijkstra’s Algorithm
by Yanfang Wu and Xiao Li
Energies 2016, 9(7), 519; https://doi.org/10.3390/en9070519 - 5 Jul 2016
Cited by 8 | Viewed by 6456
Abstract
Utilization of hydraulic-fracturing technology is dramatically increasing in exploitation of natural gas extraction. However the prediction of the configuration of propagated hydraulic fracture is extremely challenging. This paper presents a numerical method of obtaining the configuration of the propagated hydraulic fracture into discrete [...] Read more.
Utilization of hydraulic-fracturing technology is dramatically increasing in exploitation of natural gas extraction. However the prediction of the configuration of propagated hydraulic fracture is extremely challenging. This paper presents a numerical method of obtaining the configuration of the propagated hydraulic fracture into discrete natural fracture network system. The method is developed on the basis of weighted fracture which is derived in combination of Dijkstra’s algorithm energy theory and vector method. Numerical results along with experimental data demonstrated that proposed method is capable of predicting the propagated hydraulic fracture configuration reasonably with high computation efficiency. Sensitivity analysis reveals a number of interesting observation results: the shortest path weight value decreases with increasing of fracture density and length, and increases with increasing of the angle between fractures to the maximum principal stress direction. Our method is helpful for evaluating the complexity of the discrete fracture network, to obtain the extension direction of the fracture. Full article
Show Figures

Figure 1

12238 KiB  
Article
Experimental Study of Crack Initiation and Extension Induced by Hydraulic Fracturing in a Tree-Type Borehole Array
by Yiyu Lu, Shaojie Zuo, Zhaolong Ge, Songqiang Xiao and Yugang Cheng
Energies 2016, 9(7), 514; https://doi.org/10.3390/en9070514 - 30 Jun 2016
Cited by 33 | Viewed by 4723
Abstract
High-pressure hydraulic fracturing technology in coal and coal bed methane mines can lead to roof and floor damage, and fracture initiation disorder that leads to a “blank area”, and other issues. A new method of hydraulic fracturing is proposed to increase the homogeneous [...] Read more.
High-pressure hydraulic fracturing technology in coal and coal bed methane mines can lead to roof and floor damage, and fracture initiation disorder that leads to a “blank area”, and other issues. A new method of hydraulic fracturing is proposed to increase the homogeneous permeability of coal in underground coalmines. Numerical and other simulation tests for different forms of a tree-type, branched borehole model are presented. The results show that the branched array causes cracks to initiate from the bottom of the array, and these extend along the direction of the adjacent boreholes. Generally, as the number of branched boreholes increases, the coal seam fracture network also increase, improving the distribution of the fracture network, making the fracturing effect better. The branched boreholes appear to reduce initiation pressure and, with increasing branches, the initiation pressure decreases. A model with four tree-type, branched boreholes leads to a reduction in initiation pressure of 69%. In terms of permeability improvement technology in underground coalmines, a branched hydraulic fracturing borehole array has the advantages of reducing initiation pressure, controlling crack initiation and extension, enhancing the fracturing effect and reducing the destruction of the roof and floor. Full article
Show Figures

Figure 1

Back to TopTop