Next Article in Journal
Evaluating Orientation Effects on the Fire Reaction Properties of Flax-Polypropylene Composites
Next Article in Special Issue
Modeling the Optical Properties of a Polyvinyl Alcohol-Based Composite Using a Particle Swarm Optimized Support Vector Regression Algorithm
Previous Article in Journal
Microencapsulation of Curcumin in Crosslinked Jelly Fig Pectin Using Vacuum Spray Drying Technique for Effective Drug Delivery
Previous Article in Special Issue
Role of Chemically Functionalization of Bamboo Fibers on Polyethylene-Based Composite Performance: A Solution for Recycling
 
 
Article
Peer-Review Record

Nanomodification, Hybridization and Temperature Impact on Shear Strength of Basalt Fiber-Reinforced Polymer Bars

Polymers 2021, 13(16), 2585; https://doi.org/10.3390/polym13162585
by Karolina Ogrodowska *, Karolina Łuszcz and Andrzej Garbacz
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Polymers 2021, 13(16), 2585; https://doi.org/10.3390/polym13162585
Submission received: 13 July 2021 / Revised: 28 July 2021 / Accepted: 30 July 2021 / Published: 4 August 2021
(This article belongs to the Special Issue Polymer Composites for Structural Applications)

Round 1

Reviewer 1 Report

the paper describes the preparation of fiber reinforced polymer composites and compares some mechanical properties between composites containing different kinds of fibers.

in my opinion, to explain the different behaviour observed, some considerations on the nature of the interactions originating between the chemically different fibers and the matrix could be useful. A study carried out with scanning electron microscopy on the original materials, after heating and after deformation could support  and explain the results. The use of silica fibers functionalyzed with aminopropyltrimethoxysilane could significanly improve the strength of the interaction between the fibers and the matrix acting the aminogroup of the silane derivative as  hardener for the epoxy precursor.

Author Response

Thank you for your answer very much. 

Thank you for the very important considerations regarding interactions originating between the chemically different fibers and the matrix. At this stage, I did not perform scanning microscopy after heating and after deformation. I am sure that your comments are very important, but I do not have the possibility to do a SEM analysis now.

Best regards,
Karolina Ogrodowska 

Reviewer 2 Report

I can recommend  the paper  "Nanomodification, hybridization and temperature impact on shear strength of basalt fiber reinforced polymer bars” for the publication in the  journal  “ Polymers”.

In this paper was experimental  study on the fiber-reiforced polymer composites.

Polymer hybrid   composites were created as a result of striving to obtain higher and higher properties of    this materials. 

For studies of this systems used  the mechanical and thermal  of these composites.

In the paper shows the improvement of the temperature and mechanical properties of these composite materials.

I think this paper will be interesting for readers of this journal .

I am recommending to include in the references the next publications:

1.S.P. Repetsky, I. G. Vyshyvana,Y.Nakazawa,S. P. Kruchinin, S.Bellucci., Electron transport in carbon nanotubes with adsorbed chromium impurities.Materials (2019), 12, 524.

2.Vlaskina S., Kruchinin S.. Rodionov V., Nanostructures in silicon carbide crystals and films Inter.J.Mod.Phys. B. vol.30, N13 ,p.1042015 (2016).

Author Response

Thank you for your accourate comments and suggestions.

Thank you also for recommending me interesting publications.

I will keep them in my mind during a literature review for my future paper.
 
Back to TopTop