Search Results (77)

One of the main technological challenges in plasma wakefield acceleration (PWFA) research and development is achieving stable and reproducible acceleration. In particular, for PWFA schemes based on particle-driven plasma wave excitation, beam stability and timing jitter are increasingly critical. In these configurations, magnetic or radio-frequency (RF) compression schemes are often used, and the beam time-of-arrival jitter at the end of the linear accelerator can be strongly correlated with the phase noise of RF accelerating structures operated off-crest. For this reason, since 2008, an RF phase fast-feedback system acting within each RF pulse has been successfully implemented at Laboratori Nazionali di Frascati, Istituto Nazionale di Fisica Nucleare (LNF-INFN) at the Sources for Plasma Accelerators and Radiation Compton with Laser And Beam (SPARC_LAB) facility, operating on both S-band ($2.856$ GHz) and C-band ($5.712$ GHz) klystrons. This paper presents the upgrade and optimization of the fast-feedback system for an S-band klystron powered by a pulse-forming network modulator. This technology introduces significantly higher intrinsic phase noise than, for instance, solid state-based modulators. It is therefore essential to minimize such phase fluctuations to keep the machine stability under control. Both the feedback hardware (electronic boards and RF circuitry) and the software (controller and user interface) have been upgraded. Tests performed at SPARC_LAB achieved a reduction in klystron-induced jitter of a factor of 30, reaching values below 15 fs rms on both power plants. Moreover, adding a remote control of the feedback loop enabled a straightforward optimization of the operating point, allowing the phase stability performance to be pushed close to its practical limits. A detailed analysis of RF phase noise measurements with the fast-feedback loop in operation is also presented. Full article

Nowadays, there is a deep interest in developing more compact user facilities, and plasma technology is one of the most promising techniques, not only for acceleration modules, but also for what is ancillary to the delivery of radiation to users, such as free electron lasers. In this regard, significant efforts have been made to miniaturize diagnostic stations, detection devices, and transfer lines, e.g., based on active plasma lenses. However, conventional undulators are still too cumbersome and expensive to meet the requirements of compactness and sustainability. For the aforementioned reasons, advanced undulator concepts have aroused great interest in pushing the frontier beyond conventional, magnet-based undulators. In this regard, a promising, very compact alternative is the use of the betatron motion of electrons in an ion channel to emulate an undulator device. This paper reports a feasibility study aiming to develop plasma-based undulator devices at SPARC_LAB as the test facility of the EuPRAXIA@SPARC_LAB project. In particular, this work provides a systematic assessment of free-electron-laser amplification in a plasma ion-channel undulator under experimentally realistic beam parameters, delivering quantitative predictions for gain and radiation performance in this configuration. Full article

We investigate laser wakefield electron acceleration in a periodic plasma density profile using 2D PIC simulations with the EPOCH code. The profile of the electron density has the form $n\left(x\right)=n_0\left(1+\delta sin2\pi x/x_0\right)$, where $n_0$ is the steady electron density, $x_0=100\mathrm{m}$ is the spatial periodicity in the laser propagation direction and $\delta$, taking the values 0, $0.1$, $0.3$, $0.5$ and $0.7$, is the modulation parameter. The bubble size varies with the modulated plasma density, thereby influencing the electron acceleration, which occurs within a continuously changing bubble structure. We propose an analytical model to estimate the energies of the accelerated electrons, and evaluate the maximum electron energies at $500 \mathrm{f}\mathrm{s}$ intervals for the five modulated density profiles. We then calculate the dephasing and depletion lengths for these modulated plasma profiles and examine their dependence on $\delta$. The results show a growth in both lengths with $\delta$, with depletion being the main limitation in these cases. Additionally, we compute and compare the transverse emittance of the self-injected electron bunches corresponding to the various density profiles at the same simulation time, and other characteristics, like the center energy and energy spread. Emittance is observed to experience a decrease with the increase in the modulation parameter. Full article

This study employs a comprehensive bibliometric analysis to map the global scientific landscape of laser wakefield acceleration (LWFA) from 1990 to 2025. Using data extracted from the Web of Science (WoS) and analyzed with Bibliometrix, VOSviewer, and CiteSpace, the study identifies key publication trends, influential authors, leading countries, prominent journals, and thematic evolution within the field. The findings reveal exponential growth in LWFA-related research, driven by advances in high-power laser technology and controlled injection techniques. Network analyses demonstrate extensive international collaboration and a strong interdisciplinary structure linking plasma physics, optics, and accelerator science. Keyword co-occurrence and burst analyses highlight emerging topics such as ionization injection, dual-stage acceleration, betatron radiation, and machine learning-assisted optimization. These insights delineate both the historical progression and the dynamic frontiers of LWFA, providing a systematic understanding of its development and guiding future research toward the realization of compact, high-quality electron sources and next-generation plasma-based accelerators. Full article

The present article reports on the generation of stable 50 pC low-divergence electron beams above 150 MeV from laser-driven wakefield acceleration using a continuous-flow gas target prototype tested at the 60 TW Salle Jaune facility at LOA. The gas target design is meant to be easily transported and integrated as an element of the beamline with a differential pumping system offering some 10⁻⁴ mbar pressure in the rest of the line. A dedicated gas injection system allows for the control of the gas mixture concentration and gas pressure in two different regions of the target within the frame of controlled ionisation injection schemes. The measured electron beam parameters show the importance of gas density profiles and longitudinal gas mixture confinement. Full article

EuPRAXIA@SPARC_LAB is an FEL (Free-Electron Laser) user facility currently under construction at INFN-LNF in the framework of the EuPRAXIA collaboration. The electron beam will be accelerated to 1 GeV by an X-band RF linac followed by a plasma wakefield acceleration stage. This high-brightness linac requires diagnostic devices able to measure the beam parameters with high accuracy and resolution. To monitor the beam energy and its spread, magnetic dipoles and quadrupoles will be installed along the linac, in combination with viewing screens and CMOS cameras. Macroparticle beam dynamics simulations have been performed to determine the optimal energy measurement setup in terms of accuracy and resolution. Similar diagnostics evaluations have been carried out for the spectrometer installed at the 100 MeV RF linac of the radioactive beam facility SSRIP (IFIN-HH, Romania), whose commissioning, foreseen for 2026, will be performed by INFN-LNF in collaboration with IFIN-HH. Optics measurements have been performed to characterize the resolution and magnification of the optical system that will be used at SSRIP, and probably also at EuPRAXIA@SPARC_LAB, for beam energy monitoring. Full article

Laser-accelerated electron beams, in the so-called Very High-Energy Electron (VHEE) energy range, are of great interest for biomedical applications. For instance, laser-driven VHEE beams are envisaged to offer suitable compact accelerators for the promising field of FLASH radiotherapy. Radiobiology experiments carried out using laser-driven beams require the real-time knowledge of the dose delivered to the sample. We have developed an online dose monitoring procedure, using an Integrating Current Transformer (ICT) coupled to a suitable collimator, that allows the estimation of the delivered dose on a shot-to-shot basis under suitable assumptions. The cross-calibration of the measured charge with standard offline dosimetry measurements carried out with RadioChromic Films (RCFs) is discussed, demonstrating excellent correlation between the two measurements. Full article

We present the Virtual Beamline (VBL) application, an interactive web-based platform for visualizing high-intensity laser–matter interactions using particle-in-cell (PIC) simulations, with future potential for experimental data visualization. These interactions include ion acceleration, electron acceleration, $\gamma$-flash generation, electron–positron pair production, and attosecond and spiral pulse generation. Developed at the ELI Beamlines facility, VBL integrates a custom-built WebGL engine with WebXR-based Virtual Reality (VR) support, allowing users to explore complex plasma dynamics in non-VR mode on a computer screen or in fully immersive VR mode using a head-mounted display. The application runs directly in a standard web browser, ensuring broad accessibility. VBL enhances the visualization of PIC simulations by efficiently processing and rendering four main data types: point particles, 1D lines, 2D textures, and 3D volumes. By utilizing interactive 3D visualization, it overcomes the limitations of traditional 2D representations, offering enhanced spatial understanding and real-time manipulation of visualization parameters such as time steps, data layers, and colormaps. Users can interactively explore the visualized data by moving their body or using a controller for navigation, zooming, and rotation. These interactive capabilities improve data exploration and interpretation, making VBL a valuable tool for both scientific analysis and educational outreach. The visualizations are hosted online and freely accessible on our server, providing researchers, the general public, and broader audiences with an interactive tool to explore complex plasma physics simulations. By offering an intuitive and dynamic approach to large-scale datasets, VBL enhances both scientific research and knowledge dissemination in high-intensity laser–matter physics. Full article

This review explores two main topics: the state-of-the-art and emerging capabilities of high-peak-power, ultrafast (picosecond and femtosecond) long-wave infrared (LWIR) laser technology based on CO₂ gas laser amplifiers, and the current and advanced scientific applications of this laser class. The discussion is grounded in expertise gained at the Accelerator Test Facility (ATF) of Brookhaven National Laboratory (BNL), a leading center for ultrafast, high-power CO₂ laser development and a National User Facility with a strong track record in high-intensity physics experiments. We begin by reviewing the status of 9–10 μm CO₂ laser technology and its applications, before exploring potential breakthroughs, including the realization of 100 terawatt femtosecond pulses. These advancements will drive ongoing research in electron and ion acceleration in plasma, along with applications in secondary radiation sources and atmospheric energy transport. Throughout the review, we highlight how wavelength scaling of physical effects enhances the capabilities of ultra-intense lasers in the LWIR spectrum, expanding the frontiers of both fundamental and applied science. Full article

Recently, it has been experimentally shown that the sheath acceleration of protons from ultra-thin metal targets irradiated by sub-picosecond laser pulses of intensities above ${10}^{21}$ W/cm² is suppressed compared to well-established models. This detrimental effect has been attributed to a self-generation of gigagauss-level quasi-static magnetic fields in expanded plasmas on the rear side of a target. Here we present a set of numerical simulations which support this statement. Based on 2D full-scale PIC simulations, it is shown that the scaling of a cutoff energy of the accelerated protons with intensity deviates from a well-established Mora model for laser pulses with a duration exceeding 500 fs. This deviation is showed to be connected to effective magnetization of the hottest electrons producing at the maximum of the laser pulse intensity. We propose a modification of the Mora model which incorporates the effect of the possible electron magnetization. Comparing it to the simulation results shows that by appropriately choosing a single fitting parameter, the model produces results that quantitatively coincide with simulations. Full article

This work studied the pre-plasma that builds up in interactions of focused high-power PW-class lasers with solid targets at the target surface facing the laser beam, and its impact on the global laser absorption efficiency as well as on the spectral cut-off energy of laser-generated proton beams. Our practical heuristic estimates were derived from the example of the VEGA-3 laser at CLPU. Our modeling results for the pre-plasma expansion due to the laser pedestal of VEGA-3 were benchmarked by hydrodynamic simulations, revealing good agreement for the evolution before the arrival of the main Gaussian laser intensity peak. Our detailed numerical two-dimensional Particle-in-Cell simulations showed the impact of different pre-plasma scale lengths on the absorption efficiency of laser energy into electrons, relevant for the seeding of other types of radiation. It was shown that the absorption can increase manyfold when increasing the pre-plasma scale length. This effect can be beneficial for the spectral cut-off energy of accelerated protons, where a trade-off between absorption and electron dynamics yields an optimum pre-plasma scale length. The findings can be applied to other PW-class laser facilities. Full article

We demonstrate a method to characterize the beam energy, transverse profile, charge, and dose of a pulsed electron beam generated by a 1 kHz TW laser-plasma accelerator. The method is based on imaging with a scintillating screen in an inhomogeneous, orthogonal magnetic field produced by a wide-gap magnetic dipole. Numerical simulations were developed to reconstruct the electron beam parameters accurately. The method has been experimentally verified and calibrated using a medical LINAC. The energy measurement accuracy in the 6–20 MeV range is proven to be better than 10%. The radiation dose has been calibrated by a water-equivalent phantom, RW3, showing a linear response of the method within 2% in the 0.05–0.5 mGy/pulse range. Full article

This study investigated the potential for efficient and resourceful utilization of phosphogypsum (PG) through the preparation of a High-volume Phosphogypsum Cement Stabilized Road Base (HPG-CSSB). The investigation analyzed the unconfined compressive strength (UCS), water stability, strength formation mechanism, microstructure, and pollutant curing mechanism of HPG-CSSB by laser diffraction methods (LD), X-ray diffraction (XRD), fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), and inductively coupled plasma-mass spectrometry (ICP-MS). The optimal mix ratio of HPG-CSSB was 4% cement, 1% CA2, 35% PG, and 60% graded crushed stone. The UCS reached 6.6 MPa, 9.3 MPa, and 11.3 MPa at 7, 28, and 60 d, respectively. The alkaline curing agent stimulated cement activity and accelerated the release of Ca²⁺ and SO₄²⁻ from the PG. This formed many C-S-H gels and ettringite (AFt). The curing agent converted Ca²⁺ to C-(A)-S-H gels due to high volcanic ash activity. The diverse hydration products strengthened HPG-CSSB. The HPG-CSSB exhibits favorable water stability, demonstrating a mere 7.6% reduction in strength following 28 d of immersion. The C-S-H gel and AFt generated in the system can carry out ion exchange and adsorption precipitation with F⁻ and PO₄³⁻ in PG, achieving the curing effect of toxic and hazardous substances. HPG-CSSB meets the Class A standard for integrated wastewater discharge. Full article

In this paper, the results of a Particle-in-Cell (PIC) simulation of electrons accelerated using a 10 fs Top-hat (TH) beam with a limited pulse energy of 85 mJ, focused on a double nozzle gas target using an off-axis parabola (OAP), an axiparabola (AXP), and an axiparabola with additional spatial–temporal coupling (AXP+STC), are discussed. The energy of accelerated electrons was predominantly determined through self-focusing and the ionisation injection effects of the laser beam propagating in plasma. The maximal energy of electrons accelerated using an AXP+STC could be higher by 12% compared to the energy of electrons accelerated by the regular OAP. Full article