energies-logo

Journal Browser

Journal Browser

Insulating Liquids and Dielectric Materials

A special issue of Energies (ISSN 1996-1073). This special issue belongs to the section "D1: Advanced Energy Materials".

Deadline for manuscript submissions: closed (31 October 2019) | Viewed by 5301

Special Issue Editor


E-Mail Website
Guest Editor
School of Information Technology and Electrical Engineering, University of Queensland, Brisbane St Lucia, QLD 4072, Austrilia
Interests: condition monitoring of power apparatus; alternatives for insulating oil; performance studies of HV insulators and energy related studies

Special Issue Information

Dear Colleagues,

The service lifetime and performance of many power system assets are largely determined by insulating materials, predominantly in liquid and solid form. These insulating materials are subjected to extreme stresses. In addition, to cater for new operating challenges induced by renewable generations, one has to explore the behaviour of the insulating material under those new circumstances. Insulating liquids should also be able to provide adequate cooling for the assets. In recent years, many attempts have been made to develop new techniques to assess the quality of insulation in power system assets and investigate new materials to meet the modern technical, economic, and social requirements of these assets. The demand for alternative insulating liquids is ever increasing due to various shortcomings of mineral oil such as environmental and sustainability concerns, flammability, and limitations in cooling capacity. Not only liquids but also new solid insulation materials such as polymers and nanocomposites have been introduced to improve the operating performance of the assets’ insulating system. The physical, electrical, and chemical properties of alternative insulating materials are different from traditional insulating materials, and therefore new studies are required to thoroughly understand the behaviour and ageing of insulating materials under current operating conditions. In this Special Issue, researchers are encouraged to address the new developments associated with liquid insulation and solid dielectric materials.

Dr. Chandima Ekanayake
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Energies is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • dielectrics
  • ageing
  • condition monitoring
  • thermal, electrical, and high-frequency stresses

Published Papers (2 papers)

Order results
Result details
Select all
Export citation of selected articles as:

Research

10 pages, 2353 KiB  
Article
Analysis of High-Frequency Dispersion Characteristics of Capacitance and Loss Factor of Aramid Paper Impregnated with Various Dielectric Liquids
by Stefan Wolny
Energies 2019, 12(6), 1063; https://doi.org/10.3390/en12061063 - 19 Mar 2019
Cited by 4 | Viewed by 2154
Abstract
This paper presents research results of the loss factor of high voltage insulation samples made of aramid paper impregnated with various types of insulating oil. The analysis was carried out in the high frequency domain in the range of 50 Hz to 1 [...] Read more.
This paper presents research results of the loss factor of high voltage insulation samples made of aramid paper impregnated with various types of insulating oil. The analysis was carried out in the high frequency domain in the range of 50 Hz to 1 MHz. The experiments were carried out for three impregnation types: mineral oil, synthetic ester and natural ester. The influence of temperature in the range of 20 °C to 100 °C, which is typical when using this type of insulation in power transformers, was taken into account. In addition, the process of influence of initial aging of aramid paper was simulated by heat soaking the samples before their impregnation at a temperature of 250 °C in multiple time intervals. Based on the analyses of dispersion characteristics of insulation sample loss factors, conclusions and recommendations for further diagnostics of aramid-oil insulations using the method described were delineated. Full article
(This article belongs to the Special Issue Insulating Liquids and Dielectric Materials)
Show Figures

Figure 1

17 pages, 1233 KiB  
Article
A Synthetic Condition Assessment Model for Power Transformers Using the Fuzzy Evidence Fusion Method
by Fenglan Tian, Zhongzhao Jing, Huan Zhao, Enze Zhang and Jiefeng Liu
Energies 2019, 12(5), 857; https://doi.org/10.3390/en12050857 - 5 Mar 2019
Cited by 18 | Viewed by 2808
Abstract
Condition-based maintenance decision-making of transformers is essential to electric enterprises for avoiding financial losses. However, precise transformer condition assessment was tough to accomplish because of the negligence of the influence of bushing and accessories, the difficulty of fuzzy grade division, and the lack [...] Read more.
Condition-based maintenance decision-making of transformers is essential to electric enterprises for avoiding financial losses. However, precise transformer condition assessment was tough to accomplish because of the negligence of the influence of bushing and accessories, the difficulty of fuzzy grade division, and the lack of reasonable fuzzy evidence fusion method. To solve these problems, a transformer assessing model was proposed in the paper. At first, an index assessing system, considering the main body, the bushing and the accessories components, was established on the basis of components division of transformers. Then, a Cauchy membership function was employed for fuzzy grades division. Finally, a fuzzy evidence fusion method was represented to handle the fuzzy evidences fusion processes. Case studies and the comparison analysis with other methods were performed to prove the effectiveness of this model. The research results confirm that the proposed model could be recommendation for condition based maintenance of power transformers for electric enterprises. Full article
(This article belongs to the Special Issue Insulating Liquids and Dielectric Materials)
Show Figures

Figure 1

Back to TopTop