applsci-logo

Journal Browser

Journal Browser

Power Systems: Protection and Connection with Converters

A special issue of Applied Sciences (ISSN 2076-3417). This special issue belongs to the section "Electrical, Electronics and Communications Engineering".

Deadline for manuscript submissions: closed (31 October 2024) | Viewed by 2679

Special Issue Editor


E-Mail Website
Guest Editor
Department of Electrical, Computer and Software Engineering, Ontario Tech University, Oshawa, ON L1G 0C5, Canada
Interests: HVDC and FACTS controllers for power transmission systems; modeling of power electronics converters; control and protection of power systems; microgrids
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

The integration of intermittent renewable energy sources (such as solar and wind) into microgrids requires the use of power electronic converters with sophisticated controllers to maximise their energy recuperation. There are major problems with the use of such power electronic converters. They have limited thermal ratings and contribute little, if any, rotational inertia to the microgrids that they are connected to. The lack of injected rotational enertia makes these microgrids particularly vulnerable to instability issues. Special protection and control strategies are therefore needed to efficiently and fully utilize such converters in the integration of intermittent renewable energy sources. These power electronic converters can have the role of either grid following or grid forming. Modern control techniques can enable these converters to provide virtual inertia to overcome instability issues. This Special Issue will deal with many of these topics.

Prof. Dr. Vijay K. Sood
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Applied Sciences is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Benefits of Publishing in a Special Issue

  • Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
  • Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
  • Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
  • External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
  • e-Book format: Special Issues with more than 10 articles can be published as dedicated e-books, ensuring wide and rapid dissemination.

Further information on MDPI's Special Issue policies can be found here.

Published Papers (2 papers)

Order results
Result details
Select all
Export citation of selected articles as:

Research

Jump to: Review

17 pages, 4832 KiB  
Article
Fault Detection and VSC-HVDC Network Dynamics Analysis for the Faults in Its Host AC Networks
by Kiran Rana, Nand Kishor, Richa Negi and Monalisa Biswal
Appl. Sci. 2024, 14(6), 2378; https://doi.org/10.3390/app14062378 - 12 Mar 2024
Cited by 3 | Viewed by 1487
Abstract
High-voltage direct current (HVDC) transmission is preferred over high-voltage alternating current (HVAC) for long power lines for asynchronous power grid interconnection and high-level renewable energy integration. The control and protection functions associated with HVDC systems help with fast and secure clearance of faults. [...] Read more.
High-voltage direct current (HVDC) transmission is preferred over high-voltage alternating current (HVAC) for long power lines for asynchronous power grid interconnection and high-level renewable energy integration. The control and protection functions associated with HVDC systems help with fast and secure clearance of faults. The control and protection challenges in the embedded HVDC network are of great concern for the stable and secure operation of an HVDC network. The DC fault current may reach an extremely high level in a rather short period because of the low impedance in a DC system, which is dangerous for converters, and disturbances in the AC network directly influence the performance of the HVDC system. Sometimes, faults on the AC side may lead to disconnection or failure of the DC link, causing reliability problems as well as huge economic losses. AC and DC protection solutions are being developed for HVDC systems to enhance their sustainability and reliability. As such, AC and DC faults should be detected and cleared at a faster rate. Therefore, in this article, the feasibility of the synchro-squeezed transform (SST) is analyzed for detection purposes. For more accurate and faster detection, the signal is first decomposed using the empirical mode decomposition (EMD) technique, and then the SST is applied. A discrete Teager energy (DTE) spectrum is obtained with the processed signal, which works as the detection index. The algorithm shows low sampling frequency requirements, with higher efficiency and reliability for the purpose. PSCAD/EMTDC version 4.6 software and MATLAB 2022a software is used for the modeling and simulation. Full article
(This article belongs to the Special Issue Power Systems: Protection and Connection with Converters)
Show Figures

Figure 1

Review

Jump to: Research

21 pages, 3464 KiB  
Review
Alternatives for Connecting Photovoltaic Generators to Power Systems with Three-Port and Partial Power Converters
by Donghui Ye and Sergio Martinez
Appl. Sci. 2024, 14(24), 11880; https://doi.org/10.3390/app142411880 - 19 Dec 2024
Viewed by 711
Abstract
Solar electricity has become one of the most important renewable power sources due to rapid developments in the manufacturing of photovoltaic (PV) cells and power electronic techniques as well as the consciousness of environmental protection. In general, PV panels are connected to DC-DC [...] Read more.
Solar electricity has become one of the most important renewable power sources due to rapid developments in the manufacturing of photovoltaic (PV) cells and power electronic techniques as well as the consciousness of environmental protection. In general, PV panels are connected to DC-DC converters and/or DC-AC inverters to implement the maximum power point tracking algorithm and to fulfill the load requirements. Thus, power conversion efficiency and power density need to be taken into consideration when designing PV systems. Three-port and partial power conversion technologies are proposed to improve the efficiency of a whole PV system and its power density. In this paper, three types of three-port converters (TPCs), including fully isolated, partly isolated, and non-isolated TPCs, are studied with detailed discussions of advantages, disadvantages, and comparisons. In addition, based on partial power conversion technologies, partial power two-port and three-port topologies are analyzed in detail. Their efficiency and power density can be further improved by the combination of three-port and partial power conversion technologies. Moreover, comparisons among seven different types of distributed PV systems are presented with their advantages and disadvantages. Compared to distributed PV systems without energy storage, distributed PV systems with hybridization of energy storage and with partial power regulation can use solar energy in a more efficient way. Full article
(This article belongs to the Special Issue Power Systems: Protection and Connection with Converters)
Show Figures

Figure 1

Back to TopTop