Wind, Volume 4, Issue 4 (December 2024) – 8 articles

In this study, the loads induced by tornado-like vortices on scaled models of eight low-rise residential buildings with real-world shapes in a typical North American community are quantified and compared to the provisions provided by ASCE/SEI 7–22. Physical simulations of the interaction between translating tornado-like vortices representative of EF1-, EF2- and EF3-rated tornadoes and the scaled models were performed in the WindEEE Dome at the University of Western Ontario. Three internal pressure scenarios were numerically simulated. The tornado velocity gust factor was identified as a critical parameter when translating loads from the model to full-scale. The uplift forces on the whole roof in the internal pressure scenarios with one dominant opening are between 44% and 63% higher than the distributed leakage scenario, highlighting the importance of keeping the integrity of the envelope. Revised values of the internal pressure coefficients and external pressure coefficients or correction factors may be used to improve the ability of the standard to provide safer design loads. Full article

This paper offers a basic analysis for strategic decision-makers of the process when an economy shifts from oil to non-carbon energy exports and zero carbon emissions. The fundamental concept is how to offer environmental performance without causing an economic contraction. The costs and feasibility of solar, wind, and helium closed-cycle technologies are thoroughly and independently compared. Solar panels make up 0.67% of the USD 1.14 trillion total cost of solar energy, which is the capital investment, with panels accounting for 0.51%. Future technical developments are expected to bring down the cost of such solar farms to USD 0.74 trillion. Turbines comprise 66% of the estimated USD 0.67 trillion wind energy costs. At USD 0.36 trillion, helium closed-cycle gas turbines—which account for 0.78% of the overall cost—are essential for stabilising energy output. With a focus on cost viability, this analysis offers direction for Libya’s transition to energy self-sufficiency and export, in support of global carbon reduction targets. It also offers unique insights into areas not previously covered by other studies. This paper’s unique contribution is its economic analysis of the decarbonisation of an entire oil-exporting nation. Full article

The increasing demand for cost-effective floating offshore wind turbines (FOWTs) necessitates streamlined mass production and efficient assembly strategies. This research investigates the assembly and integration of 15 MW FOWT floaters, utilising a semi-submersible floater equipped with a 15 MW wind turbine. The infrastructure and existing port facilities of Taiwan are used as an example. The effectiveness of various assembly and integration strategies has been evaluated. The study outlines equipment and infrastructure requirements for on-quay floater and turbine assembly, comparing on-quay assembly to construction at remote locations and subsequent towing. Detailed analyses of port operations, crane specifications, and assembly procedures are presented, emphasising the critical role of crane selection and configuration. The findings indicate that on-quay assembly at one major port is feasible and cost-effective, provided that port infrastructure and operational logistics are optimised. This research offers insights and recommendations for implementing large-scale FOWT projects, contributing to advancing offshore wind energy deployment. Full article

In an investigation into how wind turbine noise interacts with the surrounding terrain, its propagation over rough ground is simulated using a parabolic equation code using a modified effective impedance model, which characterizes the effects of a three-dimensional, rigid roughness within a relatively long wavelength limit ($\mathrm{k}\mathrm{a}\le 1$). The model is validated by comparison to experiments conducted within an anechoic chamber wherein different source–receiver geometries are considered. The relative sound pressure level spectra from the parabolic equation code using the modified effective impedance model highlight a sensitivity to the roughness parameters. At a low frequency and far distance, the relative sound pressure level decreased as the roughness coverage increased. A difference of 4.9 dB has been reported. The simulations highlight how the roughness shifts the ground effect dips, resulting in the sound level at the distance of 2 km being altered. However, only the monochromatic wave has been discussed. Further work on broadband noise is desirable. Furthermore, due to the long wavelength limit, only a portion of audible wind turbine noise can be investigated. Full article

Climate change is increasing the occurrence of extreme weather events, such as intense windstorms, with a trend expected to worsen due to global warming. The growing intensity and frequency of these events are causing a significant number of failures in power distribution grids. However, understanding the nature of extreme wind events and predicting their impact on distribution grids can help and prevent these issues, potentially mitigating their adverse effects. This study analyzes a structured method to predict distribution grid disruptions caused by extreme wind events. The method utilizes Machine Learning (ML) models, including K-Nearest Neighbors (KNN), Random Forest (RF), Support Vector Machine (SVM), Decision Trees (DTs), Gradient Boosting Machine (GBM), Gaussian Process (GP), Deep Neural Network (DNN), and Ensemble Learning which combines RF, SVM and GP to analyze synthetic failure data and predict power grid outages. The study utilized meteorological information, physical fragility curves, and scenario generation for distribution systems. The approach is validated by using five-fold cross-validation on the dataset, demonstrating its effectiveness in enhancing predictive capabilities against extreme wind events. Experimental results showed that the Ensemble Learning, GP, and SVM models outperformed other predictive models in the binary classification task of identifying failures or non-failures, achieving the highest performance metrics. Full article

Wind speed (and direction) estimated from numerical weather prediction (NWP) models is essential to wind energy applications, especially in the absence of reliable fine scale spatio-temporal wind information. This study evaluates four high-resolution wind speed numerical datasets (UERRA MESCAN-SURFEX, CERRA, COSMO-REA6, and NEWA) against in situ observations from coastal meteorological stations in the eastern Mediterranean basin. The evaluation is based on statistical comparisons of long-term wind speed data from 2009 to 2018 and involves an in-depth statistical comparison as well as a preliminary wind power density assessment at or near the meteorological station locations. The results show that while all datasets provide valuable insights into regional wind variability, there are notable differences in model performance. COSMO-REA6 and UERRA exhibit higher variability in wind speed but tend to underestimate extreme values, particularly in the southern coastal areas, whereas CERRA and NEWA provided closer fits to observed wind speeds, with CERRA showing the highest correlation at most stations. NEWA data, where available, overestimate average wind speeds but capture extreme values well. The comparison reveals that while all datasets provide valuable insights into the spatial and temporal variability of wind resources, their performance varies by location and season, emphasizing the need for the careful selection and potential calibration of these models for accurate wind energy assessments. The study provides essential groundwork for leveraging these datasets in planning and optimizing offshore wind energy projects, contributing to the region’s transition to renewable energy sources. Full article

In large wind farms, the interaction of atmospheric turbulence and wind turbine wakes leads to complex vortex dynamics and energy dissipation, resulting in reduced wind velocity and subsequent loss of wind power. This study investigates the influence of vortex stretching on wind power fluctuations within wind turbine wakes using scale-adaptive large eddy simulation. The proper orthogonal decomposition method was employed to extract the most energetic contributions to the wind power spectra. Vertical profiles of mean wind speed, Reynolds stresses, and dispersive stresses were analyzed to assess energy dissipation rates. Our simulation results showed excellent agreement when compared with wind tunnel data and more advanced numerical models, such as the actuator line model and the actuator line model with hub and tower effects. This highlights the important role of coherent and energetic flow components in the spectral behavior of wind farms. The findings indicate a persistent energy cascading length scale in the wake of wind turbines, emphasizing the vertical transport of energy to turbine blades. These results complement existing literature and provide new insights into the dynamics of wind turbine wakes and their impact on wind farm performance. Full article

This paper presents the design and analysis of an efficient energy management system for a wind lens integrated with a permanent magnet synchronous generator (PMSG) and a zeta converter. The wind lens, a ring-shaped structure encircling the rotor, enhances the turbine’s capability to capture wind energy by increasing the wind influx through the turbine. In the contemporary wind energy sector, PMSGs are extensively employed due to their superior performance characteristics. This study integrates a 1 kW PMSG system with a wind lens to optimize power extraction from the wind energy conversion system (WECS) under varying wind speeds. A comparative analysis of different control strategies for maximum power point tracking (MPPT) is conducted, including the incremental conductance (INC) method and the perturb and observe (P&O) method. The performance of the MPPT controller integrated with the wind lens-based PMSG system is assessed based on output DC voltage and power delivered to the load. To evaluate the overall effectiveness of these control strategies, both steady-state voltage and dynamic response under diverse wind conditions are examined. The system is modeled and simulated using the MATLAB R2023a/Simulink 9.1 software, and the simulation results are validated to demonstrate the efficacy of the proposed energy management system. Full article