Next Article in Journal
Absorption Wavebands for Discriminating Oxidation Time of Engine Oil as Detected by FT-IR Spectroscopy
Previous Article in Journal
Linear and Nonlinear Viscoelastic Modulus of Rubber
Article Menu
Issue 3 (March) cover image

Export Article

Open AccessArticle

A CFD-Based Frequency Response Method Applied in the Determination of Dynamic Coefficients of Hydrodynamic Bearings. Part 1: Theory

Department of Mechanical Engineering, The University of Akron, Akron, OH 44325-3903, USA
*
Author to whom correspondence should be addressed.
Lubricants 2019, 7(3), 23; https://doi.org/10.3390/lubricants7030023
Received: 24 January 2019 / Revised: 5 March 2019 / Accepted: 6 March 2019 / Published: 11 March 2019
(This article belongs to the Special Issue Fluid-Film Lubrication II)
  |  
PDF [889 KB, uploaded 12 March 2019]
  |  

Abstract

A general, CFD-based frequency response method for obtaining the dynamic coefficients of hydrodynamic bearings is presented. The method is grounded in experimental parameter identification methods and is verified for an extremely long, slider bearing geometry as well as short and long journal bearing geometries. The influence of temporal inertia on the dynamic response of the bearings is discussed and quantified through the inclusion of added mass coefficients within the mechanical models of the hydrodynamic bearing films. Methods to separate the dynamic stiffness into static stiffness and added mass contributions are presented and their results compared. Harmonic perturbations are applied to the bearings at varying frequencies to determine the frequency dependence of the dynamic coefficients and to facilitate the decomposition of the dynamic stiffness into its constituents. Added mass effects are shown to be significant for the extremely long slider bearing geometry and negligible for the short and long journal bearing geometries under operating conditions motivated by those typical of marine bearings. View Full-Text
Keywords: hydrodynamic lubrication; dynamic coefficients; CFD; frequency response function hydrodynamic lubrication; dynamic coefficients; CFD; frequency response function
Figures

Figure 1

This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited (CC BY 4.0).
SciFeed

Share & Cite This Article

MDPI and ACS Style

Snyder, T.; Braun, M. A CFD-Based Frequency Response Method Applied in the Determination of Dynamic Coefficients of Hydrodynamic Bearings. Part 1: Theory. Lubricants 2019, 7, 23.

Show more citation formats Show less citations formats

Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Related Articles

Article Metrics

Article Access Statistics

1

Comments

[Return to top]
Lubricants EISSN 2075-4442 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert
Back to Top