Search Results (7)

In addition to technical issues related to the instruments used, differences between soil moisture (SM) measured using ground-based methods and microwave remote sensing (RS) can be related to the main features of the study areas, which are intricately connected to hydraulic–hydrological conditions and soil properties. When long-term analysis is performed, these discrepancies are mitigated by the contribution of SM seasonality and are only evident when high-frequency variations (i.e., signal anomalies) are investigated. This study sought to examine the responsiveness of SM to seasonal variations in terrestrial ecoregions located in areas covered by the in situ Romanian Soil Moisture Network (RSMN). To achieve this aim, several remote sensing-derived retrievals were considered: (i) NASA’s Soil Moisture Active and Passive (SMAP) L4 V5 model assimilated product data; (ii) the European Space Agency’s Soil Moisture and Ocean Salinity INRA–CESBIO (SMOS-IC) V2.0 data; (iii) time-series data extracted from the H115 and H116 SM products, which are derived from the analysis of Advanced Scatterometer (ASCAT) data acquired via MetOp satellites; (iv) Copernicus Global Land Service SSM 1 km data; and (v) the “combined” European Space Agency’s Climate Change Initiative for Soil Moisture (ESA CCI SM) product v06.1. An initial assessment of the performance of these products was conducted by checking the anomaly of long-term fluctuations, quantified using the Absolute Variation of Local Change of Environment (ALICE) index, within a time frame spanning 2015 to 2020. These correlations were then compared with those based on raw data and anomalies computed using a moving window of 35 days. Prominent correlations were observed with the SMAP L4 dataset and across all ecoregions, and the Balkan mixed forests (646) exhibited strong concordance regardless of the satellite source (with a correlation coefficient R_ALICE > 0.5). In contrast, neither the Central European mixed forests (No. 654) nor the Pontic steppe (No. 735) were adequately characterized by any satellite dataset (R_ALICE < 0.5). Subsequently, the phenological seasonality and dynamic behavior of SM were computed to investigate the effects of the wetting and drying processes. Notably, the Central European mixed forests (654) underwent an extended dry phase (with an extremely low p-value of 2.20 × 10⁻¹⁶) during both the growth and dormancy phases. This finding explains why the RSMN showcases divergent behavior and underscores why no satellite dataset can effectively capture the complexities of the ecoregions covered by this in situ SM network. Full article

Satellite observations have provided global and regional soil-moisture estimates in the last four decades. However, the accuracy of these observations largely depends on reducing uncertainties in the retrieval algorithms. In this study, we address two challenges affecting the quality of soil-moisture estimates from a widely used soil-moisture-retrieval model, the land parameter retrieval model (LPRM). We studied two improvement schemes that were aimed at reducing uncertainties in open water signals (the LPRMv6_OWF) and vegetation signals (the LPRMv6_Veg), as well as a scheme to reduce their combined impacts (the LPRMv6_OWFVeg) on LPRM-retrieved soil moisture using the FengYun-3B (FY-3B) satellite observations. To assess the impacts of the improvement schemes, we utilized in situ soil moisture from the Jiangsu and Jiangxi provinces in China. We found that the retrievals (Rs) of the LPRMv6_Veg and the LPRMv6_OWFVeg were mainly in the range of 0.2 to 0.5 in Jiangsu and Jiangxi, with increases of 0.1 compared to those of the LPRMv6. The standard deviation (SD) of the LPRMv6_OWFVeg increased in Jiangsu, while the R of the LPRMv6_OWF increased in Jiangsu by 0.05–0.1 compared to that of the LPRMv6, but the SD tended to become worse. In Jiangxi, there was an increase of 0.1 in R. The results show that each of these algorithms improved the accuracy of soil-moisture inversion to some extent, compared to the original algorithm, with the LPRMv6_OWFVeg showing the greatest improvement, followed by the LPRMv6_Veg. The accuracy of both the LPRMv6_OWF and the LPRMv6_OWFVeg decreased to some extent when the open-water fraction (OWF) was greater than 0.2. Full areal extent analyses based on triple collocation showed significant improvements in correlations and minimized errors across different vegetation scenarios over the entire region of China in both the LPRMv6_OWF and the LPRMv6_Veg. However, reduced qualities were found in arid regions in northern China because of the nonlinear relationships between land-surface temperature, vegetation, and soil moisture in the LPRM. These results highlight important lessons for developing comprehensive improvement schemes for soil-moisture retrievals from passive microwave satellite observations. Full article

L-band passive microwave remote sensing (RS) is an important tool for monitoring global soil moisture (SM) and freeze/thaw state. In recent years, progress has been made in its in-depth application and development in the Tibetan Plateau (TP) which has a complex natural environment. This paper systematically reviews and summarizes the research progress and the main applications of L-band passive microwave RS observations and associated SM retrievals on the TP. The progress of observing and simulating L-band emission based on ground-, aircraft-based and spaceborne platforms, developing regional-scale SM observation networks, as well as validating satellite-based SM products and developing SM retrieval algorithms are reviewed. On this basis, current problems of L-band emission simulation and SM retrieval on the TP are outlined, such as the fact that current evaluations of SM products are limited to a short-term period, and evaluation and improvement of the forward land emission model and SM retrieval algorithm are limited to the site or grid scale. Accordingly, relevant suggestions and prospects for addressing the abovementioned existing problems are finally put forward. For future work, we suggest (i) sorting out the in situ observations and conducting long-term trend evaluation and analysis of current L-band SM products, (ii) extending current progress made at the site/grid scale to improve the L-band emission simulation and SM retrieval algorithms and products for both frozen and thawed ground at the plateau scale, and (iii) enhancing the application of L-band satellite-based SM products on the TP by implementing methods such as data assimilation to improve the understanding of plateau-scale water cycle and energy balance. Full article

Compared with co-polarized (HH/VV) normalized radar cross-section (NRCS) backscattered from the sea surface, there is no saturation phenomenon in cross-polarized (HV/VH) NRCS when wind speed is greater than about 20 m/s, so cross-polarized synthetic aperture radar (SAR) images can be used for high wind speed monitoring. In this work, a new geophysical model function (GMF) is proposed to describe the relation of the C-band cross-polarized NRCS with wind speed and radar incidence angle. Here, sixteen ScanSAR wide mode SAR images acquired by RADARSAT-2 (RS-2) under tropical cyclone (TC) conditions and the matching wind speed data from the European Centre for Medium-Range Weather Forecasts (ECMWF) and the Stepped-Frequency Microwave Radiometer (SFMR) are collected and divided into datasets A and B. Dataset A is used for analyzing the effects of the wind field and radar incidence angle on the reference noise-removed cross-polarized NRCS, and for proposing the new GMF for each sub-swath of the SAR images, while dataset B is used to retrieve wind speed and evaluate the validity of the new GMF. The comparisons between the wind speeds retrieved by the new GMF and the collocated ECMWF and SFMR data demonstrate the excellent performance of the new GMF for wind speed retrieval. To analyze the universality of the new GMF, wind speed retrievals based on 32 Sentinel-1A/B (S-1A/B) extra-wide-swath (EW) mode images acquired under TC conditions are also compared with the collocated wind speeds measured by the Soil Moisture Active Passive (SMAP) radiometer, and the retrieved wind speeds have RMSE of 3.667 m/s and a bias of 2.767 m/s. The successful applications in high wind speed retrieval of different tropical cyclones again supports the availability of the new GMF. Full article

The massive use of pesticides in agriculture has led to widespread contamination of the environment, particularly the atmospheric compartment. Thirty-six pesticides, most used in viticulture, were monitored in ambient air using polyurethane foams as passive air samplers (PUF-PAS). Spatiotemporal data were collected from the samplers for 10 months (February–December 2013), using two different sampling times (1 and 2 months) at two different sites in a chateau vineyard in Gironde (France). A high-volume active air sampler was also deployed in June. Samples were extracted with dichloromethane using accelerated solvent extraction (ASE) (PUFs from both passive and active) or microwave-assisted extraction (MAE) (filters from active sampling). Extracts were analyzed by both gas and liquid chromatography coupled with tandem mass spectrometry. A total of 23 airborne pesticides were detected at least once. Concentrations in PUF exposed one month ranged from below the limits of quantification (LOQs) to 23,481 ng PUF⁻¹. The highest concentrations were for folpet, boscalid, chlorpyrifos-methyl, and metalaxyl-m—23,481, 17,615, 3931, and 3324 ng PUF⁻¹. Clear seasonal trends were observed for most of the pesticides detected, the highest levels (in the ng m⁻³ range or the µg PUF⁻¹ range) being measured during their application period. Impregnation levels at both sites were heterogeneous, but the same pesticides were involved. Sampling rates (Rs) were also estimated using a high-volume active air sampler and varied significantly from one pesticide to another. These results provide preliminary information on the seasonality of pesticide concentrations in vineyard areas and evidence for the effectiveness of PUF-PAS to monitor pesticides in ambient air. Full article

In recent decades, microwave remote sensing (RS) has been used to measure soil moisture (SM). Long-term and large-scale RS SM datasets derived from various microwave sensors have been used in environmental fields. Understanding the accuracies of RS SM products is essential for their proper applications. However, due to the mismatched spatial scale between the ground-based and RS observations, the truth at the pixel scale may not be accurately represented by ground-based observations, especially when the spatial density of in situ measurements is low. Because ground-based observations are often sparsely distributed, temporal upscaling was adopted to transform a few in situ measurements into SM values at a pixel scale of 1 km by introducing the temperature vegetation dryness index (TVDI) related to SM. The upscaled SM showed high consistency with in situ SM observations and could accurately capture rainfall events. The upscaled SM was considered as the reference data to evaluate RS SM products at different spatial scales. In regard to the validation results, in addition to the correlation coefficient (R) of the Soil Moisture Active Passive (SMAP) SM being slightly lower than that of the Climate Change Initiative (CCI) SM, SMAP had the best performance in terms of the root-mean-square error (RMSE), unbiased RMSE and bias, followed by the CCI. The Soil Moisture and Ocean Salinity (SMOS) products were in worse agreement with the upscaled SM and were inferior to the R value of the X-band SM of the Advanced Microwave Scanning Radiometer 2 (AMSR2). In conclusion, in the study area, the SMAP and CCI SM are more reliable, although both products were underestimated by 0.060 cm³ cm⁻³ and 0.077 cm³ cm^−3, respectively. If the biases are corrected, then the improved SMAP with an RMSE of 0.043 cm³ cm⁻³ and the CCI with an RMSE of 0.039 cm³ cm⁻³ will hopefully reach the application requirement for an accuracy with an RMSE less than 0.040 cm³ cm⁻³. Full article

Remote sensing (RS) soil moisture (SM) products have been widely used in various environmental studies. Understanding the error structure of data is necessary to properly apply RS SM products in trend and variation analysis and data fusion. However, a spatially continuous assessment of RS SM datasets is impeded by the limited spatial distribution of ground-based observations. As an alternative, the RS apparent thermal inertia (ATI) data related to the SM are transformed into SM values to expand the validation space. To obtain error components, the ATI-based SM along with the Soil Moisture Active Passive Mission (SMAP) and Advanced Microwave Scanning Radiometer 2 (AMSR2) SM are applied with the triple-collocation (TC) method to evaluate the RS SM data regarding random errors and amplitude variances at the regional scale. When the ATI-based SM is regarded as the reference data, the amplitude biases of the other two datasets are determined. The mean bias is also estimated by calculating the mean value difference between the ATI-based and validated RS SM. The results show that the ATI-based SM is a reliable source of reference data that, when combined with the TC method, can correctly estimate the error structure of RS SM datasets in wide space, promoting the reasonable application and calibration of RS SM datasets. Full article