Conference Reports
4th International Symposium on Sensor Science (I3S2015): Conference Report
Sensors 2015, 15(9), 24458-24465; https://doi.org/10.3390/s150924458
An international scientific conference was sponsored by the journal Sensors under the patronage of the University of Basel. The 4th edition of the International Symposium on Sensor Science (I3S2015) ran from 13 to 15 July 2015 in Basel, Switzerland. It comprised five plenary sessions and one morning with three parallel sessions. The conference covered the most exciting aspects and the latest developments in sensor science. The conference dinner took place on the second evening of the conference. The I3S2015 brought together 170 participants from 40 different countries. [...]
Full text download
Full text download
GNSS Signal Tracking Performance Improvement for Highly Dynamic Receivers by Gyroscopic Mounting Crystal Oscillator
Sensors 2015, 15(9), 21673-21695; https://doi.org/10.3390/s150921673
In this paper, the efficiency of the gyroscopic mounting method is studied for a highly dynamic GNSS receiver’s reference oscillator for reducing signal loss. Analyses are performed separately in two phases, atmospheric and upper atmospheric flights. Results show that the proposed mounting reduces signal loss, especially in parts of the trajectory where its probability is the highest. This reduction effect appears especially for crystal oscillators with a low elevation angle g-sensitivity vector. The gyroscopic mounting influences frequency deviation or jitter caused by dynamic loads on replica carrier and affects the frequency locked loop (FLL) as the dominant tracking loop in highly dynamic GNSS receivers. In terms of steady-state load, the proposed mounting mostly reduces the frequency deviation below the one-sigma threshold of FLL (1σFLL). The mounting method can also reduce the frequency jitter caused by sinusoidal vibrations and reduces the probability of signal loss in parts of the trajectory where the other error sources accompany this vibration load. In the case of random vibration, which is the main disturbance source of FLL, gyroscopic mounting is even able to suppress the disturbances greater than the three-sigma threshold of FLL (3σFLL). In this way, signal tracking performance can be improved by the gyroscopic mounting method for highly dynamic GNSS receivers.
Full text download
Full text download
