Antibacterial Nanomaterials Coating: Fabrication and Applications
A special issue of Nanomanufacturing (ISSN 2673-687X).
Deadline for manuscript submissions: closed (14 December 2021) | Viewed by 421
Special Issue Editor
Special Issue Information
Dear Colleagues,
Antimicrobial resistance (AMR) has become one of the major health issues in the 21st century. The problem of AMR has become more serious with the increase rate of antibiotic-resistant bacteria. Over several decades, bacteria have developed more resistance to each new antibiotic coming to market. Faced with this reality, the need for action to develop the strategy for antibacterial materials in health care is imperative. Nanomaterials are a very promising approach for the next-generation of antibacterial coatings. Antimicrobial surfaces are important in everyday applications, ranging from healthcare purposes to food and agricultural applications. Different fabrications can be utilised to design the antimicrobial surfaces, like the immobilisation of antibacterial agents into the matrix of materials, slow-release of antibacterial agents, functionalisation of surfaces to prevent the bacterial adhesion, and nanostructuring the surfaces to prevent and inhibit the growth of bacteria.
In this context, this Special Issue welcomes the submission of original research works as well as reviews dealing with antibacterial surfaces. Topics can range from fabrication to applications of antibacterial coatings.
You may choose our Joint Special Issue in Nanomaterials.
Dr. Vi-Khanh Truong
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Nanomanufacturing is an international peer-reviewed open access quarterly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 1000 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- antimicrobial coatings
- antibacterial surfaces
- fabrication
- characterisation
- applications
Benefits of Publishing in a Special Issue
- Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
- Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
- Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
- External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
- e-Book format: Special Issues with more than 10 articles can be published as dedicated e-books, ensuring wide and rapid dissemination.
Further information on MDPI's Special Issue polices can be found here.
