Hollow Fiber Membranes 2021

A special issue of Fibers (ISSN 2079-6439).

Deadline for manuscript submissions: closed (31 March 2022) | Viewed by 4443

Special Issue Editor

Department of Chemistry and Environmental Science, New Jersey Institute of Technology, Newark, NJ 07102, USA
Interests: membrane-based separation and purification
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

Hollow fiber is one of the most popular membranes employed for commercial use. The separation and purification technologies based on hollow fiber membranes (HFMs) have become extremely important in various fields of application, including gas separation, pervaporation, agriculture, medicine, desalination, waste treatment, etc. The primary aim of this Special Issue is to capture the recent scientific and technological advances in the development of HFMs, and their potential applications. The Special Issue will also seriously consider the challenges and future research directions. Considering your extensive knowledge and experience in this field, I would like to invite you to contribute original research articles, as well as review articles, to this Special Issue, which will increase the basic and cutting-edge subject knowledge on hollow fibers, and may lead to the development of new technologies and innovations for their efficient and economic utilization.

Dr. Sagar Roy
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Fibers is an international peer-reviewed open access monthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2000 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • Hollow fiber membranes (HFMs)
  • Advanced materials for HFMs
  • Applications of HFMs
  • Designing and fabrication of improved HFMs
  • Novel nanomaterials enabled HFMs

Benefits of Publishing in a Special Issue

  • Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
  • Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
  • Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
  • External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
  • e-Book format: Special Issues with more than 10 articles can be published as dedicated e-books, ensuring wide and rapid dissemination.

Further information on MDPI's Special Issue polices can be found here.

Published Papers (1 paper)

Order results
Result details
Select all
Export citation of selected articles as:

Research

25 pages, 6650 KiB  
Article
Application of Capillary Polypropylene Membranes for Microfiltration of Oily Wastewaters: Experiments and Modeling
by Wirginia Tomczak and Marek Gryta
Fibers 2021, 9(6), 35; https://doi.org/10.3390/fib9060035 - 2 Jun 2021
Cited by 9 | Viewed by 3636
Abstract
Oily wastewaters are considered as one of the most dangerous types of environmental pollution. In the present study, the microfiltration (MF) process of model emulsions and real oily wastewaters was investigated. For this purpose, capillary polypropylene (PP) membranes were used. The experiments were [...] Read more.
Oily wastewaters are considered as one of the most dangerous types of environmental pollution. In the present study, the microfiltration (MF) process of model emulsions and real oily wastewaters was investigated. For this purpose, capillary polypropylene (PP) membranes were used. The experiments were conducted under transmembrane pressure (TMP) and feed flow rate (VF) equal to 0.05 MPa and 0.5 m/s, respectively. It was found that the used membranes ensured a high-quality permeate with turbidity equal to about 0.4 NTU and oil concentration of 7–15 mg/L. As expected, a significant decrease in the MF process performance was noted. However, it is shown that the initial decline of permeate flux could be slightly increased by increasing the feed temperature from 25 °C to 50 °C. Furthermore, Hermia’s models were used to interpret the fouling phenomenon occurring in studied experiments. It was determined that cake formation was the dominant fouling mechanism during filtration of both synthetic and real feeds. Through detailed studies, we present different efficient methods of membrane cleaning. Results, so far, are very encouraging and may have an important impact on increasing the use of polypropylene MF membranes in oily wastewater treatments. Full article
(This article belongs to the Special Issue Hollow Fiber Membranes 2021)
Show Figures

Figure 1

Back to TopTop