Advanced Materials for Defense: From Textiles to Composites, 2nd Edition

A special issue of Applied Sciences (ISSN 2076-3417). This special issue belongs to the section "Materials Science and Engineering".

Deadline for manuscript submissions: 20 December 2024 | Viewed by 58

Special Issue Editor

E-Mail Website
Guest Editor

Special Issue Information

Dear Colleagues,

Research and development (R&D) on advanced materials for defense is being driven all over the world by the most renowned universities, research centers, military institutes, and companies, in order to meet important requirements to enhance the safety and survivability of platforms and personnel, along with requirements for enhanced maintainability and operability of platforms.

This Special Issue focuses on advanced materials research in the forward-looking R&D domain, where the intersection of key technologies in areas such as nano- and micro-technology, biotechnology, sensor technology, stealth materials, smart materials and structures, and energy generation and storage is being explored.

Hence, the aim of this Special Issue is to publish original research and review articles that address these topics and include advances, trends, challenges, and future perspectives in established and emerging areas of defense.

Prof. Dr. Raúl Manuel Esteves Sousa Fangueiro
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Applied Sciences is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.


  • ballistic protection
  • signature management and adaptative camouflage
  • metamaterials
  • fibers, textiles and wearable technologies
  • personal protective equipment
  • chemical, biological, radiological, and nuclear detection/protection
  • composite materials
  • radar absorbers
  • computational materials design
  • structural health monitoring
  • multifunctional coatings
  • manufacturing technology, testing and repair
  • autonomous systems
  • auxetic materials
  • blast protection
  • energy harvesting and storage
  • energy and impact absorption
  • monitoring and sensor systems
  • nanomaterials and nanostructures
  • self-healing materials
  • smart materials and structures
  • thermoregulation

Related Special Issue

Published Papers

This special issue is now open for submission.
Back to TopTop