Next Article in Journal
Urban Heat Islands in Bahrain: An Urban Perspective
Previous Article in Journal
Indoor/Outdoor Environmental Parameters and Window-Opening Behavior: A Structural Equation Modeling Analysis
Article Menu
Issue 4 (April) cover image

Export Article

Open AccessArticle

Thermal Performance Evaluation of Common Exterior Residential Wall Types in Egypt

1
Department of Architecture, School of Sciences and Engineering, American University in Cairo, New Cairo 11835, Egypt
2
Mechanical Power Department, Faculty of Engineering, Cairo University, Cairo 12613, Egypt
*
Author to whom correspondence should be addressed.
Buildings 2019, 9(4), 95; https://doi.org/10.3390/buildings9040095
Received: 28 December 2018 / Revised: 16 April 2019 / Accepted: 18 April 2019 / Published: 21 April 2019
  |  
PDF [3988 KB, uploaded 21 April 2019]
  |  

Abstract

The demand for energy-efficient housing is on the rise in Egypt. The information about the individual materials used in the construction of typical residential wall assemblies are known in the literature. However, data from lab tests to validate the performance for whole composite walls are limited. Three typical wall types were constructed and tested utilizing a standard experimental evaluation procedure based on thermal convection loads. A research framework combining the validated thermal performance data from the experimental test and the simulated data was developed. The experimental tests were performed utilizing a state-of-the-art guarded hotbox apparatus and following the guidelines of the ASTM C1363-11 standard. The solar radiation load was taken into account in the calculations according to the standard, and the error estimation and uncertainty analysis for the experimental tests are reported. The results of the experimental testing are described and a recommendation of the best wall type is noted. The output of this research will help to initiate a material database of the thermal performance of typical residential wall types used in Egypt that have been validated in the lab. This will be useful for the building industry as a whole to understand the performance of the materials in composite assemblies and their impact on energy efficiency. View Full-Text
Keywords: hotbox; experimental testing; wall systems; composite walls hotbox; experimental testing; wall systems; composite walls
Figures

Figure 1

This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited (CC BY 4.0).
SciFeed

Share & Cite This Article

MDPI and ACS Style

Tarabieh, K.; Aboulmagd, A. Thermal Performance Evaluation of Common Exterior Residential Wall Types in Egypt. Buildings 2019, 9, 95.

Show more citation formats Show less citations formats

Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Related Articles

Article Metrics

Article Access Statistics

1

Comments

[Return to top]
Buildings EISSN 2075-5309 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert
Back to Top